LOREX W463AQ_Z 2K Dual Lens Indoor Pan-Tilt Wi-Fi Security Camera User Guide

: August 27, 2024
: Lorex

Table of Contents

W463AQ_Z 2K Dual Lens Indoor Pan-Tilt Wi-Fi Security Camera
What’s Included
Smart Security Lighting Indicators
Lorex App Setup
Support
FCC Statement
Read User Manual Online (PDF format)
Download This Manual (PDF format)

W463AQ_Z 2K Dual Lens Indoor Pan-Tilt Wi-Fi Security Camera

Quick Start Guide

W463AQ_Z

What’s Included

Tools Needed: Drill & Screwdriver

Smart Security Lighting Indicators

Band

*Reset your device by holding the reset button below the camera lens until you hear the audio prompt. 1

Lorex App Setup

https://app.lorex.com/home/download

Support

For detailed instructions and additional support material, scan the QR code or visit help.lorex.com/W463AQ-series.
To find local support, visit lorex.com/pages/contact.
To register for warranty, see our full Terms of Service and Limited Hardware Warranty Policy at lorex.com/warranty.

https://www.help.lorex.com/W463AQ-series

Copyright © 2024 Lorex Technology Inc.
As our products are subject to continuous improvement, Lorex reserves the right to modify product design, specifications and prices, without notice and without incurring any obligation. E&OE. All rights reserved.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

lorex.com
help.lorex.com/W463AQ-series
W463AQ_QSG_Region1_R1

Regulatory Information

IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:

This device may not cause interference, and
This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.

FCC Statement

Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

Caution: The user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF exposure warning
This equipment must be installed and operated in accordance with provided instructions and antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
The equipment should be installed and operated with a minimum distance 20cm between the radiator and your body.
For full FCC compliance declarations, visit https://www.lorextechnology.com /FCC-compliance

Declaration of Conformity UKCA
This device complies with UKCA relevant directives and standards.
UK Declaration of Conformity (DoC) can be downloaded from: https://www.lorextechnology.com/UKCA-compliance

Lorex Technology UK Limited
1 Georges Square, Bath Street, Bristol, United Kingdom, BS1 6BA.