PHANTEKS PH-GB3090TiGBBP Innovative Computer Hardware Design Installation Guide
- June 4, 2024
- PHANTEKS
Table of Contents
PH-GB3090TiGBBP Innovative Computer Hardware Design
Installation Guide
GLACIER G3090Ti GIGABYTE BACKPLATE
PH-GB3090TIGBBP_BK01 /CR01
INSTALLATION GUIDE V1.0
PACKAGE CONTENTS
This product requires the PH-
GB3090TIGB GPU water block. Please follow step 1 to 3 of the GPU water block’s
installation guide before proceeding.
WARNING – This product is intended for advanced users. Improper
installation may result in damage to your equipment. While all efforts have
been made to provide the most comprehensive information possible, Phanteks
assumes no liability expressed or implied for any damage(s) occurring to your
components as a result of using Phanteks cooling products, either due to
mistake or omission on our part in the below instructions or due to failure or
defect in the Phanteks cooling products. Do not disassemble the water block.
The warranty will be voided.
Turn off the power to your system and discharge your body’s static electric
charge before proceeding with the installation procedure. If you do not feel
comfortable with performing the installation procedure, consult a qualified
computer technician.
FINISH STEPS 1 TO 3 ROM THE WATER BLOCK INSTALLATION GUIDE BEFORE PROCEEDING:
STEP 4. APPLYING THERMAL PADS
Remove the protective film and place the thermal pads on the correct position on the backplate.
Make sure to remove the protective film on both sides of the thermal
pads. ,
If the No.4 thermal pad is too long, please cut it out to a suitable
length.
STEP 5.INTALL THE GLACIER BACKPLATE
Carefully position the backplate onto the graphics card. Align the mounting
holes on the PCB with the holes on the backplate.
Secure the backplate with 8 M2.5x8mm flush screws to the PCB.
STEP 6. CONNECT D-RGB LIGHTING
Connect the D-RGB cable to the D-RGB strip in the water block.
All Phanteks D-RGB products can be daisy-chained together.
You can connect the D-RGB cable to a compatible motherboard with the D-RGB Motherboard Adapter.
STEP 7. INSTALLING FITTINGS
Install G1/4 threaded male fittings and close the remaining ports with the two included Stop Fittings.
**** Always perform a leak test before providing power to any system
components. 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>