STARLINK Enterprise Kit User Guide
- August 26, 2024
- Starlink
Table of Contents
STARLINK Enterprise Kit
ENTERPRISE KIT
What’s In The Box
INSTALL
Download the Starlink App
Scan the QR code to download the Starlink App.
Find A Clear View of Sky and Check for Obstructions
Your Starlink needs a clear view of the sky so it can stay connected with
satellites as they move overhead. Objects that obstruct the connection between
your Starlink and the satellite, such as a tree branch, pole, or roof, will
cause service interruptions. Use the obstruction tool in the App to ensure you
have selected a suitable mounting location.
Install Mount
Using your desired Starlink mount, install in an elevated location, like a
roof, pole, or wall. Additional mounts and accessories are available for
purchase on the Starlink Shop.
Connect and Align Starlink
Follow the cable routing instructions for your chosen Starlink mount and plug
one end of the Enterprise Cable into your Starlink. Ensure the plug is fully
inserted such that the plug face is flush with the surface. To remove the
cable, pull firmly outward as there is no release tab. Plug the other end of
the Enterprise Cable to your Power Supply.
Connect the Ethernet Cable to the power supply and the other end to a router. If you have a Starlink router, step through the Starlink install process on the Starlink App. Once connected, an alert on the App will show if you need to rotate Starlink to be properly aligned. Click the alert to use the alignment tool. If you have a compatible third-party router, follow the router’s set up instructions.
Connect to WiFi
- On your device, find and connect to the STARLINK network in your WiFi settings.
- Once connected, a browser window will open prompting you to enter a new SSID (Network name) and password. This step is optional but recommended.
- You are now connected! Open the Starlink App to customize additional settings, check your connection, and more.
POWER SUPPLY MOUNT INSTALL
Mark Pilot Holes
Remove the power supply from its mount and select a mount location no more
than 1.8 m (6ft) away from your power source. Mark the location of the two
holes on your Power Supply Mount using a pen or pencil.
Drill the Pilot Holes
Drill the holes with a 8 mm (5/16 in) drill bit.
Install Anchors and Mount
Push anchors into holes until flush with the wall. Place the wall mount over
the anchors and screw the mount into the wall until securely attached.
Plug In Cables and Power Supply
Plug the Starlink, AC and Ethernet cables into the power supply. Slide the
power supply into the mount, making sure the top clip snaps into place. Finish
installation by routing the Ethernet cable to your router install location,
connect to router and plug in router and power supply into your power source.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>