Flying Tech 5.8GHz 3W Transmitter TX 5.8ghz Video Transmitter Instruction Manual
- August 26, 2024
- FLYING TECH
Table of Contents
Flying Tech 5.8GHz 3W Transmitter TX 5.8ghz Video Transmitter
Product dimension
Specifications:
- 48CH 5.8G frequency range: (A.B.E.F.R.L; 5362MHz-5945MHz);
- Max power: 3W (25mW/1000mW/2000mW/3000mW adjustable);
- Input voltage: DC 7V-36V, supporting 2-8S battery input
- Antenna connector: MMCX
- Smart audio: IRC Tramp
- Heat-dissipating method: aluminum alloy heat sink& fan
- Hole spacing: 30.5mm*30.5mm /03.15mm
- Dimension: 37.7mm36.1 mm 11mm
- Weight: 16g
Function introduction
- Channel indicator: Red LED
- Band indicator: Blue LED
- Power level indicator: Green LED
- Band and channel changer button
- Power changer button
- 1.0 6P Power connector
- MMCX antenna connector
Control method and LED indicator
-
Button 4 is used to switch band and channel; every time when button 4 is pressed for a short time to switch to the next channel, the red LED 4 will flash, 1.2.3.4.5.6.7.8 in turn. The operation can be cyclic; see the following diagram for details!
-
Band will be switched if button 4is pressed for a long time and the blue LED will flash if the key is pressed for 5s, A.B.E.F.R.L in turn. The operation can be cyclic; see the following diagram for details!
-
Button 5 is used to switch RF power; every time when button 5 is pressed for a short time to switch to the next RF power level, RF power cycling between 25mW, 1000mW, 2000mW and 3000mW. Green LED is the RF power level indicator and its status is shown in the following diagram. 25mW LED will flash once, 1000mW twice, 2000mW for 3 times and 3000mW for 4 times. When the button is pressed and held for more than 3 seconds, the Transmitter will enter pit mode,the greenLED will remain permanently on. See the following diagram for details!
Notice: The transmitter is equipped with temperature protection function.
When the temperature of transmitter is higher than 100°C, the RF power of the
Transmitter will be lowered for one level. If the temperature is still greater
than 100°C, the power can be lowered for another level until the lowest power
(25mW) is reached; at this time, the temperature of theTransmitter module will
drop. When the temperature is lower than 95 C, the Transmitter power will
return to the originally power level.
Frequency Table
Illustrate of 6P 1.0 Wiring
Wiring Table
Notice for Use
- A certain space shall be reserved when the transmitter is installed to ensure the air convection around the module and module cooling; otherwise, if the overheating protection of the module is started, the power emission will be lowered and even closed.
- We suggested to ensure correct voltage scope and correct positive and negative anodes before powering-on to avoid element burning-out.
- We suggested to confirm antenna has been installed at the RF output terminal before powering-on to extend the service life of transmitter.
- Please read the Instruction before use to ensure correct wiring and extend the service life of transmitter.
Packing list
- 1 * 5.8GHz VTX
- 1 * MMCX interface antenna connection cable
- 1 * 6P 1.0 connecting wiring
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>