Horizon Global 63071 and 70933 Series Adjustable Dual Ball Mount Installation Guide
- August 21, 2024
- HORIZON GLOBAL
Table of Contents
Horizon Global 63071 and 70933 Series Adjustable Dual Ball Mount
Specifications
- Product Name: Adjustable Dual Ball Mount
- Part Numbers: 63071 and 70933 Series
- Maximum Weight Capacity:
- 2″ Ball : 10,000 lbs (4535 Kg)
- 2 5/16″ Ball: 14,000 lbs (6350 Kg)
- Height Adjustment Increments: 1.25 inches
Installation Instructions
Do Not Exceed the Lower of the Towing Vehicle Manufacturer’s Rating or
- 2” Ball 10,000 Lbs (4535 Kg)
- 2 5 /16” Ball 14,000 Lbs (6350 Kg)
Additional Products
- Insert the shank into the hitch receiver and attach the pin & clip (sold separately).
- Insert dual ball mount onto the shank, adjust to the proper height, and attach shank pin & clip. (Height adjustment is in increments of 1.25 inches.)
Note: See Figure 1 for the maximum drop position and Figure 2 for the maximum rise position.
Note: Check for proper ball mount height with the vehicle and trailer loaded for travel. At proper adjustment, the trailer coupler and tongue should be level with the ground. See Figure 5.
- Check the hitch frequently, making sure all fasteners are properly tightened. Grease hitch ball(s) before each use. A hitch or ball that has been damaged or worn should be removed and replaced.
- This product complies with safety specifications and requirements for connecting devices and towing systems per SAE J684.
WARNING : The attachment of this product is critical and beyond the control of Horizon Global. Horizon Global is NOT responsible for the attachment nor the installation. It neither guarantees nor will it be liable for any damage resulting from its attachment or improper use. The liability of this product is limited to its purchase price if it proves to be defective in material and/or workmanship. Warranty information is available upon request. Warranty void if hardware is damaged/worn.
©2021 Horizon Global Corp.
www.horizonglobal.com
800-632-3290 Sheet 1 of 3 63071N
3/162022 Rev. D
FAQ
- Q: Is the pin & clip included with the dual ball mount?
- A: No, the pin & clip is sold separately.
- Q: What should I do if the hitch or ball is damaged or worn?
- A: Remove and replace any damaged or worn hitch or ball immediately to ensure safe towing.
- Q: What is the warranty information for this product?
- A: Warranty information is available upon request. The warranty is void if the hardware is damaged or worn.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>