American 1895ALM 16 Inch 5 Blade Classic Reel Lawn Mower Instruction Manual

American 1895ALM 16 Inch 5 Blade Classic Reel Lawn Mower

PACKING LIST

• Reel Mower
• 4 Piece Handles (See Figure 1)
• Instruction Manual
• Handle Assembly Hardware Package

SAFETY INSTRUCTION

• Read the manual before use and ensure the mower is in safe operating condition.
• Remove debris and foreign objects from the lawn before mowing.
• Keep hands and feet away from moving parts and avoid placing them inside the reel.
• Walk slowly, maintain secure footing, and avoid mowing wet grass.
• Exercise caution, avoid intentional collisions, and treat the mower as precision equipment.

ASSEMBLY INSTRUCTIONS

ASSEMBLY HARDWARE

INSTRUCTIONAL VIDEO

Scan QR code

• Visit www.americanlawnmower.com/howto/classichandle
• Call 844-531-3063 if further instruction is needed.

HANDLE ASSEMBLY INSTRUCTIONS

1. Install the metal connector (4) onto the center handle (6). (Fig. A)
2. Locate the square nut (5) into the square hole in the center handle, and align the upper handle(3), saddle washer (2), and hex-head bolt Mi0x80(1) with the square nut to secure them in place. (Fig. B &C)
3. Position a bolt sleeve (11) in the middle of two bottom handles (10). Insert the M6x60 cup-head bolt (7) through the holes on the bottom handles and bolt sleeve to secure the two bottom handles with a washer (9) and a cap nut (8). Remember not to over-tighten. (Fig. D &E)
4. Align the two holes on the center handle with holes on the lower handles, use two M6x60 bolts to go through the holes, and secure the lower handles to the assembled upper and center handles tightly by two washers (9) and two cap nuts (8). Tighten all the bolts on the handles. (Fig. F&G)

ATTACHING THE HANDLE TO THE MOWER

1. DO NOT attempt to attach the handle to the bolts on the roller assembly at the rear of the mower. This is incorrect! As you follow the instructions below, refer to FIGURE 2 for more information.
2. After assembling the handle, fit the holes at the end of the lower portion of the handle on the left and right side, over the short posts extending out from the side plates.

REPLACEMENT PART KITS

USAGE AND CARE

1. To prevent unnecessary wear on blades, pull the reel mower rather than push when you are not cutting grass.
2. Apply a light coating of oil or WD-40 to the blades after every use.

MINOR CUTTING HEIGHT ADJUSTMENTS

Adjustable from. 5 inches to 2 1/2 inches (1,27cm to 6,35cm) (FIGURE 3)

1. To lower the cutting height, loosen and remove the nuts on both sides of the roller assembly.
2. Position the bolt through the bottom hole of the plastic roller bracket and the top hole of the mower side plate. Retighten nuts on both sides.
3. To increase the cutting height, loosen and remove the nuts on both sides of the roller assembly.
4. Position the bolt through the top hole of the plastic roller bracket and the bottom hole of the mower side plate. Retighten nuts on both sides.

MAJOR CUTTING HEIGHT ADJUSTMENTS

The wheel/dust cover assembly can be moved to one of 3 positions on the side plate. Keep in mind that the same adjustment must be performed on both sides of the mower. FIGURE 4a,4b&4c

1. To remove the metal hub cap, use a flathead screwdriver to insert into the gap between the wheel and hub cap and pry the cap off. (Figure 4a)
2. Remove the axle nut on the inside of the mower by holding the axle pin in place with either a 1/2″ (1.27 cm) socket or flat-blade screwdriver and either a socket or box-end wrench on the nut.
3. Pull the wheel, dust cover, and axle pin out gently as a unit until the axle pin clears the side plate. Then, reposition in the desired hole, and replace and tighten the nuts. Position A = 1/2″ (1.27 cm) cutting height, position B = 13/4 (4.44 cm), position C = 21/2″ (6.35 cm). (Figure 4b)
4. To install the metal hub cap back onto the wheel, make sure the tabs on the edge of the cap sit inside of the wheel slot and press each tab in place with the last one left. Use the flat-head screwdriver to push the last tab into the slot and ensure all the tabs now sit tightly in the wheel frame without any unevenness. (Figure 4c)

SHARPEN YOUR BLADE

• SK-1 American Lawn Mower Reel Mower Sharpening Kit

Scan QR code

• Visit https://americanlawnmower.com/products/sk-1
• SK-2 American Lawn Mower Reel Mower Hand Sharpener

Scan QR code

• Visit https://americanlawnmower.com/products/american-lawn-mower-reel-mower-sharpening-kit

CUTTING BAR RESET INSTRUCTIONAL VIDEO

Reel Mower Bar Reset

• Scan QR code
• Visit http://www.americanlawnmower.com/howto/cuttingbar .

HEIGHT ADJUSTMENT VIDEO

• Scan QR code
• Visit http://www.americanlawnmower.com/how-to/bracketheight
• Call 844-531-3063 if further instruction is needed.

WARRANTY

There are no warranties that extend beyond the product description except that the lawn mower sold thereunder is warranted as follows:

2 YEARS LIMITED WARRANTY.

• For 2 years from purchase, The Great States Corporation/American Lawn Mower Company will replace free of charge to the original buyer, any parts) found defective in material and/or workmanship.
• THERE IS NO OTHER EXPRESS WARRANTY. ALL IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO 2 YEARS FROM THE PURCHASE AND THE EXTENT PERMITTED BY LAW, AND ALL IMPLIED WARRANTIES ARE EXCLUDED. THIS IS THE EXCLUSIVE REMEDY AND LIABILITY FOR CONSEQUENTIAL DAMAGES UNDER ANY AND ALLI WARRANTIES.
• Warranty is limited to manual push walk-behind applications and specifically excludes any non-manual powered propulsion of any kind or any commercial/ non-residential applications.

ANY NON-RESIDENTIAL USE OF THIS PRODUCT VOIDS ALL WARRANTY.

• This warranty is not transferable and only applies to products sold directly from an authorized retailer.
• Proof of purchase and original dated sales receipt must accompany all warranty claims.

California Proposition 65 Warning

• This product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
• WARNING: Some dust and debris created by the use of this tool could contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
• chemicals in fertilizers
• compounds in insecticides, herbicides, and pesticides
• arsenic and chromium from chemically treated lumber.
• Your risk from exposure to these chemicals varies, depending on how often you do this type of work.
• To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specifically designed to filter out microscopic particles.
• WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov

Documents / Resources

| American 1895ALM 16 Inch 5 Blade Classic Reel Lawn Mower [pdf] Instruction Manual
1895ALM 16 Inch 5 Blade Classic Reel Lawn Mower, 1895ALM, 16 Inch 5 Blade Classic Reel Lawn Mower, Classic Reel Lawn Mower, Reel Lawn Mower
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>