American Pro Decor 5APD11844 Round Flat Crimp Decorative Antique Brass Woven Wire Grille Panel Instructions
- October 27, 2023
- American Pro Decor
Table of Contents
American Pro Decor 5APD11844 Round Flat Crimp Decorative Antique Brass
Woven Wire Grille Panel
RECOMMENDATIONS FOR CUTTING GRILLES
STEP 1:
We suggest making a template of the desired grille size, made of heavy paper
or cardboard.
Measure the routed opening that the grille will need to be placed into –
deduct 1/8″ from each dimension for clearance.
EXAMPLE: Outer edges of routed opening measure 14″ x 28″.
Template should measure 13 7/8 x 27-7/8.
STEP 2:
Place the template on a flat surface large enough to hold the grille material.
Lay the grille over the template and position it so the design is centered
from top to bottom and from side to side. Be sure that wires ·run into· each
corner (see illustration below}.
STEP 3:
Using a permanent ink mart<er or lumber crayon. mark the grill wires
corresponding to your template.
(If more than one grille of each size is to be cut. use a marker to outline
one ‘diamond’ on the template near each of the four corners. This will assist
in positioning the remaining material on the template).
STEP 4:
Cut the grrlle with wire or bolt cutters, carefully followmg your marked
lines. Any loose comer wires may be secured once the grille Is mounted into
the routed opening.
American Pro Décor assumes no liability for improper Installation
Documents / Resources
|
American Pro Decor 5APD11844 Round Flat Crimp Decorative Antique Brass Woven
Wire Grille
Panel
[pdf] Instructions
5APD11844, Round Flat Crimp Decorative Antique Brass Woven Wire Grille Panel,
5APD11844 Round Flat Crimp Decorative Antique Brass Woven Wire Grille Panel,
Crimp Decorative Antique Brass Woven Wire Grille Panel, Antique Brass Woven
Wire Grille Panel, Woven Wire Grille Panel, Grille Panel, Panel
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>