ProtoArc EM15 Wireless Mouse User Manual
- August 19, 2024
- ProtoArc
Table of Contents
ProtoArc EM15 Wireless Mouse User Manual
support@protoarc.com
www.protoarc.com
United States: (+1) 866-287-6188
Monday-Friday: 10am-1 pm, 2pm-7pm (Eastern Time)
*closed during Holidays
Product Features
- A Left Button
- B DPI / Low Battery Indicator
- C Formvars Button
- D Scroll wheel
- E Forward Button
- F Backward Button
- G Charging Indicator
- H DPI Button
- I TYPE-C Charging Port
- J USB Connection Indicator
- K Type-G Connection Indicator
- L Power Switch
- M Type-C Receiver
- N USB Receiver
- O Chanel Switch Button
DPI Button
Press the DPI button to adjust the . A single flash of indicator light
corresponds to DPI level 800, two to 1200, three to 1600.
Jiggle Mode:
- Press and hold the DPI button for 3-5 seconds, and the red light on tl1e scroll wheel will light up, entering the jiggle mode.
- Press and hold the DPI button again for 3-5 seconds, and the red light on the scroll Wheel will light up, exiting the Juggler mode.
- After entering the juggler mode, you can still control the mouse cursor. When idle for 5 seconds, it will automatically switch back to Juggler mode.
- It’s important to note that the juggler function is attached lo the receiver. At;; long as the juggler function is turned on, even if the mouse power is turned off, the juggler function can still work normally.
- It is possible lo operate two computers enter the jiggler mode simultaneously (Connect an Apple computer to enter tM jiggler
mode, then switch to a Windows computer to enter the jiggler mode). To cancel the Juggler mode, you can press and hold the DPI button for 3s to exit the jiggler mode. Unplug the receiver or tum off the computer can also cancel the jiggler mode.
2.4G USB Connection
Type-C Connection
Charging Guide
- When the mouse power is low, the charging indicator end the corresponding flannel indicator flash until turned off.
- Insert the Type-C charging cable into the mouse, the red light stays on during charging.
- The charging time is about 1-3.5 hours and the indicator light will tum green after being fully charged.
Please use the charging cable included with the mouse lo charge.
If using another clanging cable. please make sure it is an USB-A to Type-C
cable.
Switch Connection Channel
After USB and Type-C channel is connected, press the channel switch button on the bottom of the mouse to switch between multiple devices.
Press the channel switch button on the bottom of the mouse to switch between 2 devices.
Data Parameters
Basic parameter:
Movement Detection Technology: Optical
Lithium battery Capacity: 300mAh
DPI: ,800-1200-1600
Click life: 3 million+
Dimension: 125.4.64.6*39.3mm
Weight: 2.4oz (68g)
2.4G transmission parameters:
Transmission distance: 10m
Working voltage: 3.7V
Working current: 5.5mA
Reaction rate: 125Hz
System requirement:
An available USB or Type-C port
Windows XP, Windows 7, Windows .a, Windows 10 or higher version
Mac OS x 10.10 or higher version
Packing List
► 1 x Wireless Mouse
► 1 x USB Receiver
► 1 x Type-C Receiver
► 1 x Type C Charging Cable
► 1 x User Manual