Stinger MT-600.4 Audio 1000 Watt 4 Channel Car Audio Amplifier Instruction Manual

Stinger MT-600.4 Audio 1000 Watt 4 Channel Car Audio Amplifier Instruction Manual

Power Connections

Signal Connections

Amplifier Controls

1. Frequency Multiplier
   Multiplies crossover frequency by x1 or x10

2. Crossover Filter
   Low-pass filter [LPF], passes through the frequencies below the set frequency.
   High-pass filter [HPF] passes through the frequencies above the set frequency.

3. Input Mode
   Selection between 2ch input or 4ch input

4. INPUT
   Connect to line leveroutput RCAs from head unit or line output converter (LOC).

5. Protect LED [PRT]
   Red when amplifier is powering up or in Protection Mode. See Troubleshooting for more information.
   Power LED [PWR]
   Blue when amplifier is ON.
   Clipping LED [CLIP]
   Red when amplifiers is clipping

6. Crossover Frequency
   Set the crossover frequency point. Variable from 50Hz to 5kHz utilizing Multiplier switch.

7. Not USED
   PAC Ready expansion port. Harnesses not included with amplifier.

8. GAIN
   Used to adjust the input sensitivity to match the input level signal.

9. REMOTE
   Connect the PMTRMT2 Remote Bass Control knob here.

10. Crossover Filter
    Low-pass filter [LPF], passes through the frequencies below. the set frequency.
    High-pass filter [HPF] passes through the frequencies above the set frequency.

11. Frequency Multiplier
    Multiplies crossover frequency by x1 or x10

12. BOOST
    Adjustable bass boost from OdB to 12dB. 45Hz Center frequency. CH5 Only.

13. SUBSONIC
    A high pass crossover for the subwoofer output. Variable from OFF to 50HY. Generally set between 30-35Hz

14. GAIN
    Used to adjust the input sensitivity to match the input level signal.

15. INPUT
    Connect to line level output RCAS from head unit or line output converter (LOC).

16. Crossover Frequency
    Set the crossover frequency point. Variable from 50Hz to 5kHz utilizing Multiplier switch.

17. Input Mode
    Selection between 2ch input, 4ch input or 5ch input. When 4ch is selected, ch5 is linked to ch3 and ch4

18. Protect LED [PRT]
    Red when amplifier is powering up or in Protection Mode. See Troubleshooting for more information.
    Power LED [PWR]
    Blue when amplifier is ON.
    Clipping LED [CLIP]
    Red when amplifiers is clipping

19. REMOTE
    Connect the PMTRMT2 Remote Bass Control knob here.

20. Low Pass Filter [LPF]
    Allow pass crossover for the subwoofer output. Variable from 40Hz to 180Hz. Generally set around 80Hz.

MT-600.4 Specs

RMS Power Ratings listed at less than 1% THD @ 14.4v

MT-1000.5 Specs

RMS Power Ratings listed at less than 1% THD @ 14.4v

Bridging Muilti-Channel amplifier

LIMITED WARRANTY
Stinger warrants this product to be free of defects in materials and workmanship for a period of one (1) years from the original date of purchase. This warranty is not transferable and applies only to the original purchaser from an authorized Stinger dealer in the United States of America only. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction, Stinger will (at its discretion), repair or replace the defective product with new or re-manufactured product at no charge. Damage caused by the following is not covered under war- ranty: accident, misuse, abuse, product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear is not covered under warranty.

INTERNATIONAL WARRANTIES:
Products purchased outside the United States of America are covered only by that country’s Authorized Stinger reseller and not by Stinger. Consumers needing service or warranty information for these products must contact that country’s reseller for information.

STOP! Please DO NOT return to seller
For help with installation, replacement parts, warranty or returns, please contact us directly at 727-732-3114 or support@stingerelectronics.com

Stinger is a Power Brand of AAMP Global
15500 Lightwave, Clearwater, Florida 33760
©2024 AAMP Global
MCAMP-IG REV 010624

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>