STINGER SG-3 Golf Push Buggy Instruction Manual

June 3, 2024
Stinger

STINGER SG-3 Golf Push Buggy

SG-3 Golf Push Buggy

Assembly Instructions

  1. Unpack contents from packaging and check you have the below items. Important reminder: Open the carton from the bottom.
    • SG-3 Seat
    • SG-3 Mount Bar with 2x Clamps
    • 1x Allen Key
    Unpack content

  2. Turn the SG-3 upside down and using a Phillip screw driver, unscrew the cable support clip as per images below. Keep screw and clip aside for future use.

  3. Remove clamps from Seat Mount Bar and remove screws from both clamps as per images below. Keep screws aside for future use.

  4. Place clamps on each side of the SG-3 Buggy main frame and screw into place lightly as per images below. Please note: Do not fully tighten screws at this point in time.

  5. Rotate both clamps 180 degrees as per image below. This should now look like figure 10 when in position.

  6. Begin feeding the Seat Mount Bar through the clamps, ensuring the cable is beneath the bar and the knurling is flush with both clamps as per images displayed below.

  7. Please ensure the square section of the Mounting Tube slot is closest to the ground as per image below. Please note: This is with the SG-3 buggy turned back to the upright position.

  8. Once Seat Mount Bar is in the correct position, please tighten all clamp screws as per image below.

  9. Place the SG-3 Seat on the mounting bar as per image below.
    SG-3 Golf Push Buggy

03 5924 6065
stingergolf.com.au
info@stingergolf.com.au

STINGER Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Stinger User Manuals

Related Manuals