baseus PB5676Z-P0A0 PrimeTrip C02 Mega Magnetic Wireless Car Mount User Manual

baseus PB5676Z-P0A0 PrimeTrip C02 Mega Magnetic Wireless Car Mount

Contact Us

• care@baseus.com
• https://www.baseus.com
• + 1 800 220 8056 (US)

Customer Service

1. 24-Month Warranty
2. Lifetime Tech Support

• Baseus PrimeTrip Series CO2 Mega Magnetic Wireless Charging Car Mount.
• Before using the product, thoroughly read this manual. Keep the manual for future reference.

Product Parameters

• Name : Baseus PrimeTrip Series C02 Mega Magnetic Wireless Charging Car Mount
• Model : BS-CM042
• Product materials: manganese steel + PU leather + silicone
• Input : 9V-2.5A (Max.)
• Wireless output: 5W/7.5W/15W
• Total power : 15W
• Use scenarios: center console/dashboard, etc.
• Applicable vehicle models : suitable for all vehicle models
• Accessories: gel replacement x 1, magnetic ring x 1, magnetic ring sticker X 1, alcohol pad X 1, A-C charging cable X 1, C-C charging cable X 1

Installation Instructions

Recommended use scenarios: center console/dashboard

1. Before pasting, please wipe the surface to be pasted with an alcohol pad and keep it dry and clean.
2. Remove the protective film from the gel-backed adhesive, stick the base onto the center console/dashboard, ensure that the soft base is in full contact with the bonding surface, and keep it stand for 24 hours before using.
3. Before use, bend the handle of the bracket to adjust it to the appropriate angle and position.

Precautions

1. This product is suitable for iPhone 12 and above. For iPhone 12 and below, and Android phones, please use a magnetic ring.
2. Using a case will affect the magnetic force. The magnetic ring can be attached to the surface of the phone case for use.
3. Before installation, please keep the surface to be adhered dry and clean.
4. After applying the gel, please keep it stand for 24 hours before using it.
5. The bracket handle supports over 1000 bends; please avoid multiple bends in a short period.
6. The handle shaft has a certain angle limit for bending; please do not force it to bend.

This symbol indicates that this product shall not be treated as household waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Follow local rules and never dispose of the product or batteries with regular household waste.

Compliance with reactive 2014/3/E. Tel Tue’s tent othe to the declaration of conformity is available at the following internet address: https://eu.baseus.com/pages/euro-compliance

FCC STATEMENT

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used per the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.

To maintain compliance with FCC’s RF exposure guidelines, this equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

• Manufacturer: Shenzhen Baseus Technology Co., Ltd. Add: 2nd Floor, Building B, Baseus Intelligence Park, No.2008, Xuegang Rd, Gangtou Community, Bantian Street, Longgang District, Shenzhen

• Hotline: 400-071-2711(China) / +1 800 220 8056(Global)

• Website: https://www.baseus.cn(China) / https://www.baseus.com(Global)

• Official After-sales E-mail Address:
  service@baseus.com (China) / care@baseus.com (Global) PB5676Z-POAO 1100027201

• Designed by Baseus

• Made in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>