VOLLRATH 39732W Cafeteria Breath Guard Instruction Manual
- August 14, 2024
- VOLLRATH
Table of Contents
VOLLRATH 39732W Cafeteria Breath Guard
Specifications
- Brand: Vollrath
- Model: Cafeteria Breath Guard
- Types: One Piece, Three Piece
- Item No. : 2350030-01
FAQ
- Q: What should I do if I encounter cracked plastic during installation?
- A : If you encounter cracked plastic during installation, stop tightening immediately to prevent further damage. Contact Vollrath customer service for assistance.
Installation Instructions
These instructions cover the installation of the one-piece Cafeteria Breath Guard and the three-piece Cafeteria Breath Guard.
One Piece Breath Guard Installation
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.
-
Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights
Figure 1. One Piece Breath Guard Installation -
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
-
Install the one-piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
-
Install the side breath protector (G) to the support tube (D) securing it with cap nuts (C) as shown. Repeat on the other side.
Three-Piece Breath Guard Installation
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the plastic
to crack.
-
Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights.
Figure 2. Three-Piece Breath Guard Installation -
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
-
Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
-
Install the side shield (G) to the support tube (D) securing it with cap nuts (C) as shown. Repeat on the other side.
-
Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
-
Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations
CONTACT
- The Vollrath Company, L.L.C.
- 1236 North 18th Street
- Sheboygan, WI 53081-3201
U.S.A.
- Main Tel: 800.628.0830
- Service Tel: 800.628.0832
- FAX: 800.752.5620
- Vollrath of Canada, Co.
- Tel: 800.695.8560
- FAX: 800.752.5620
- www.vollrathco.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>