samsara Unpowered Asset Gateway AG51 (AG51-EU) User Manual
- June 3, 2024
- Samsara
Table of Contents
samsara Unpowered Asset Gateway AG51 (AG51-EU)
OVERVIEW
The AG51 Unpowered Asset Tracker is a wallet-sized tracker ideal for
monitoring assets like intermodal containers, construction equipment,
dumpsters, light towers and other mobile assets etc. It features customizable
GPS check-ins, user-replaceable AA batteries that lasts 3 years and a
waterproof and ruggedized enclosure. The AG51 enables increased asset
utilization, theft recovery and optimized pool inventory management. It is
part of Samsara’s Connected Operations Cloud, enabling you to capture data
that helps you run your operations more efficiently, safely, and sustainably.
sales@samsara.com
CONNECTIVITY
Cellular LTE Cat M1
Operating area: United States, Canada, Mexico, EU (countries with LTE-M)
Offline Storage Built-in flash memory to store data when Internet
connectivity is unavailable
Security All Internet connectivity secured via HTTPS with TLS encryption
Technical Specifications
LOCATION
- GPS Advanced positioning system simultaneously reads from multiple independent satellite systems including GPS. Internal antenna for discreet installation.
- Default Check-in 2 check-ins per day
POWER
Battery 3 Energizer L91 AA batteries
Typical battery life 3 to 5 years with 2 check-ins per day. Actual battery
life may be affected by extreme temperature or cellular signal strength.
User-replaceable batteries
For questions about the safe use of AA battery powered devices, please consult
your company’s safety department
ENCLOSURE
- Material UV-stabilized polycarbonate
- Dimensions 110 x 81 x 31 mm
- Weight 168 g
- Operating Temperature -40°C to 60°C
- IP Rating IP67 (weatherproof and water resistant up to 1m submerged) IP69K (highest grade resistance to high pressure and high temperature washdown)
SAMSARA CLOUD SOFTWARE FEATURES
Features Map-based location tracking Approximate cell and WiFi based location Developer APIs Alerts Geofence
INSTALL ACCESSORIES
What’s Included 2x Phillips screws
Regulations
IC REGULATIONS
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with Innovation, Science and Economic Development Canada RF exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated to ensure a minimum of 20 cm spacing to any person at all times.
IC Radiation Exposure Statement:
This equipment complies with Canada radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for he
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Installation Statement:
This device requires professional installation and must be installed by a
trained person.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>