Insta360 X4 Standard Lens Guards Instructions

Table of Contents

Insta360-X4-Standard-Lens-Guards-product

Specifications

Installing

Align the blue mark on the Lens Guards with the lower right slot of the lens. Rotate the Lens Guards clockwise and align it with the camera’s microphone.

Turning on Lens Guard Mode

Power on the camera. Swipe down from the top of the touchscreen to access the Shortcut Menu. Look for the Lens Guard Mode icon. Tap to turn it on when the Lens Guards are installed.

Removing

Hold down the edge of the base of the Lens Guards and twist counterclockwise to remove. Turn off Lens Guard Mode on the camera.

Notes

Avoid exposing the Lens Guards to water, snow, or fog to prevent damage or fogging.

Disclaimer

Ensure all associated accessories are functioning properly before each use. Stop using if any damage or irregularity is noticed. Refer to Insta360’s warranty policies for more information.

After-Sales Service

The warranty period for the product is 3 months from the original retail purchase. Check warranty service details based on your state or jurisdiction laws. Visit the support website for detailed policies.

Q: How can I prevent fogging on the Lens Guards?

A: Avoid exposing the Lens Guards to water, snow, or fog to prevent fogging. Make sure to remove any moisture promptly.

Q: What should I do if I notice damage to the Lens Guards?

A: Stop using the Lens Guards immediately if you notice any damage. Contact customer service for further assistance.

Installing
- Align the blue mark on the Lens Guards with the lower right slot of the lens, as shown below. Then, rotate the Lens Guards clockwise and align it with the camera’s microphone.
Turn on “Lens Guard Mode
- Power on the camera. Swipe down from the top of the touchscreen to access the Shortcut Menu and you will see the “Lens Guard Mode” icon ****.
- If the icon is gray, it is turned off. Tap to turn it on when the Lens Guards are installed, and the icon will light up.
Removing
- Hold down the edge of the base of the Lens Guards and twist counterclockwise to remove. Then, turn off “Lens Guard Mode ****on the camera.

Notes

Do not squeeze or pull the base too hard when installing the Lens Guards, as this may change the shape or reduce the adhesiveness.
Ensure the Lens Guards are securely installed before using your camera. The blue mark on the Lens Guards should be aligned with the camera’s microphone.
Enable “Lens Guard Mode ****when using the Lens Guards and turn it off after removing them.
Dirty or worn Lens Guards may affect the final image result.
Avoid using the Lens Guards in water or rain due to the non-sealed structure.
To avoid fogging, dry the Lens Guards thoroughly with a soft cloth if they get wet from water, snow, or fog.

Please read this Disclaimer carefully. Using this product means that you acknowledge and accept the terms of this disclaimer.
By using this product, you hereby acknowledge and agree that you are solely responsible for your conduct when using this product and any consequences thereof. You agree to use this product only for proper and lawful purposes.
You understand and agree that Arashi Vision Inc. (hereinafter referred to as ‘Insta360’) accepts no liability for all misuse, consequences, damages, injuries, penalties, or any other legal responsibility directly or indirectly incurred by your using this product and associated accessories. Before every use, make sure that your accessories are functioning properly. If there’s any damage or irregularity, stop using them immediately.
Within the scope of state laws and regulations, Insta360 reserves the right of final explanation and revision for the commitment.

The warranty period of the attached product is 3 months from the original retail purchase.
Warranty service may vary according to the applicable laws of your state or jurisdiction. For detailed warranty policies, please visit https://insta360.com/support.

Video Tutorial