Insta360 ING2 Camera Instruction Manual
- June 6, 2024
- Insta360
Table of Contents
Insta360 ING2 Camera
Instruction Manual
Names of Parts
GO 2 Camera
GO 2 Charge Case
Open the Charge Case:
Charging
Place GO 2 into its Charge Case for charging
Connect the included charge cable to GO 2 for charging
How to Use
Press and hold the Action Button to power on GO 2, indicated with two short
vibrations.
Press and hold the Action Button for 2 seconds to power off.
Press and hold the Action Button for 6 seconds to force shutdown.
When the camera is powered on, press the Action Button to start recording (by
default).
When the camera is powered on, press the Action Button to start recording (by
default).
When the camera is powered on, press the Action Button twice in quick
succession to take a photo.
- This document is subject to change without notice. For more information, visit https://www.insta360.com/support/product-support
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
IC STATEMENT
This device complies with Industry Canada’s license-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and (2) This device must accept
any interference, including interference that may cause undesired operation of
the device.
5.2 GHz band is restricted to indoor use only
The device has been evaluated to meet general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.
References
- Insta360 | Action Cameras | 360 Cameras | VR Cameras
- Insta360 | Action Cameras | 360 Cameras | VR Cameras