OVS-2181 Modern 1.28 GPF One Pice Toilet Instruction Manual
- October 27, 2023
- OVS
Table of Contents
OVS-2181 Modern 1.28 GPF One Pice Toilet
INSTALLATION instructions
CAUTit0N: P1RODUCT IS FRAGILE. TO AVOID BREAKAGE AND1 POSSIBLE INJURY HAND, LE. WITH CAREi
RECOMMENDED TOO, LS AND MATERIALS
- Putty Knife
- Regular Screwdriver
- Adjustable Wrench
- Sealant
- Tape Measure
- Hacksaw
- Wax Ring/Gasket
- Flexible Supply Tube Closet Bolts
- Carpenters Level
REMOVE10LD l10ILET(IF NEW INSTALlATIO’N PROCEJ.EDIT STEP 2}
-
Close toset supply valve and flush tank completely. Towel or sponge remaining water fram tank and bowl
-
Disconnect and rermove supply line. NOTE: freplacing valve, first shut off main water supply!
-
Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases
-
Remove closet bolts from flange and clean away old wax, putty, etc. from base area
-
NOTE: Mounting surace must be clean and level before new toilet is instalfed
-
DIMENSIONS (Nominal)
-
NOTE: Distance from wall to closet flange center tine (rough-in) must be 12″ (305 mm) minimum
-
INSTALL CLOSET BOLTS
-
Install closet bolts in fiange channel, tum 90i and slide into place 6″ (152 mm) apart and parallel to wall
-
INSTALL WAX RING
-
Invert toilet on floor (cushion to preventdamage), and instal wax ring evenly around waste fiange (horn). with tapered end of ring facing toilet. Apply a thin bead of sealant around base flange.
-
INSTALL TOILET
-
a. Position the toilet squarely to the wall and, with a rocking motion, press the bowl down fully on wax ring and flange. Alternately tighten nuts until the toilet is firmly seated on floo
CAUTION: DO NOT OVERTIGHTEN NUTS OR BASE MAY BE
- DAMAGED!
- b. Install caps on washers. (1f needed, cut bolt height to size before installing caps.) Place a bead of sealant around base. Remove excess sealant c Smooth off the bead of sealant around base. Remove excess sealant
- CONNECT WATER SUPPLY
a. Connect water supply line between shutoff valve and tank water inlet fitting. Tighten coupling nuts securely.
b. Turn on supply valve and allow tank to fill until fioat rises to shutoff position
c. Check for leakage at fittings, tighten or correct as needed.
INSTALL TOILET SEAT I nstall toilet seat in accordance with enclosed directions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>