PYRAMID 207025 Bandit 1250 Fairing Lowers Instruction Manual
- August 6, 2024
- PYRAMID
Table of Contents
PYRAMID 207025 Bandit 1250 Fairing Lowers
Product Information
Specifications
- Kit includes:
- 2X CFK207025 GSF1250 Lower Brackets (A+B)
- 2X CBOLM60011 M6x25mm Flanged Button Head
- 2X CBOLM60008 M6x16mm Flanged Button Head
- 2X CBOLM60012 M6x30mm Flanged Button Head
- 6X CGROM60001 13mm Open Rubber Grommet
- 6X CSPAM60004 8mm Steel Collar
- 2X CWASM60007 Rubber Washer
- 2X CSPAM60010 White Plastic Spacer
- 2X CSPAM60003 Black Plastic Washer
- 2X CWASM60001 Flat Steel Washer
- 2X CNUTM60003 Nyloc Nut
- 4X CFOA0003 30mm Length Foam
Product Usage Instructions
- On both sides of the bike, remove the rear mounting of the nose fairing and the upper mounting of the radiator side. Also, remove the radiator side plates. Fig 1
- Fit the brackets for the rear belly pan mountings as shown in Fig 2 and Fig 3.
- Feed the upper mounting molding of the right-hand side panel under the rear mounting of the nose fairing and loosely fasten with the original bolt.
- Loosely fasten the radiator mounting using an M6x20mm flange-headed bolt with an M6x10mm white nylon spacer in between the panel and the radiator.
- Repeat the process for the left-hand panel.
- Place a protective cover under the bike to avoid the belly pan being scratched during fitting.
- Insert the rubber grommets into the rear mounting holes in the belly pan and insert the steel collars into the grommets. (Note: the foam pads supplied with the fitting kit are used to create a gasket between the fairing panels and the belly pan – see Fig 4)
- Offer the belly pan up to the brackets and loosely fasten to both rear brackets using M6x16mm flange-headed bolts.
- Now feed the front mountings of the belly pan under the side panels until the mountings of the belly pan and side panels match up.
- Secure the belly pan to the side panels using the remaining M6x30mm bolts attached with the following: rubber washer, black plastic washer, flat steel washer, and nyloc nut (10 full allen key rotations to fully secure).
- Check the fit and tighten all of the mountings fully.
- Remember to check all fixings periodically.
FAQ
Q: Where can I direct further questions or inquiries?
A: For any questions, you can contact sales@pyramid- plastics.co.uk or call +44 (0)1427 677990. You can also visit their website at www.pyramid-plastics.co.uk for more information.
Q: How can I provide feedback or reviews?
A: You can follow Pyramid Plastics on social media and feel free to leave a review on their platforms..
Any questions?
sales@pyramid-plastics.co.uk
+44 (0)1427 677990
www.pyramid-plastics.co.uk
Follow us on social media and feel free to leave us a review
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>