PYRAMID 059330 Superduke GT EXTRA Extenda Slit Installation Guide
- June 2, 2024
- PYRAMID
Table of Contents
PYRAMID 059330 Superduke GT EXTRA Extenda Slit
Product Specifications
- Model: 059330KTM 1290SuperdukeGT/RExtendaFendaEXTRA
- Kit Includes:
- 1X Moulding Brackets (pair) – C059330
- 2X Black Stainless Steel Bolt M5X12mm – CFK059330
- 4X Stainless Steel Washer M5 – CBOLM50005
- 8X Stainless Steel Serrated Nut M5 – CWASM50002
- 4X Foam Strip 20mm X 1.5mm – CNUTM50003 (cut to 150mm in length)
- 1X Foam Strip – CFOA0002
- 2X Push-rivets – CRIV0003
Product Usage Instructions
- Loosely attach the mudguard to the brackets using the M5 fixings supplied. Place the M5 stainless steel washers under the bolt head and the serrated nut.
- Cut and attach the foam provided in the area marked ‘A’ below.
- Remove the bottom OEM bolts from the brake calipers marked ‘B’ below.
- Attach the mudguard assembly to the brake calipers using the OEM bolts.
- Check alignment and adjust the position of the mudguard by pulling/pushing the assembly up/down if required. Avoid excessive pressure when adjusting.
- Tighten all mounting points and check fixings periodically.
Kit Includes
1X | C059330 | Molding |
---|---|---|
2X | CFK059330 | Brackets (pair) |
4X | CBOLM50005 | M5 X 12mm Black Stainless Steel Bolt |
8X | CWASM50002 | M5 Stainless Steel Washer |
4X | CNUTM50003 | M5 Stainless Steel Serrated Nut |
1X | CFOA0002 | Foam Strip 20mm X 1.5mm (cut to 150mm in length |
)
2X| CRIV0003| Push- rivets
USING INSTRUCTION
We advise the use of thread-locking fluid on all the fixings for this product
- Loosely attach the mudguard to the brackets using the M5 fixings supplied. Place the M5 stainless steel washers under the bolt head and the serrated nut.
- Cut and attach the foam provided in the area marked ‘A’ below.
- Remove the bottom OEM bolts from the brake calipers marked ‘B’ below.
- Attach the mudguard assembly to the brake calipers using the OEM bolts. Once the mudguard is in place, check alignment. The exact position of the mudguard can be adjusted by pulling/pushing the assembly up/down if required. Avoid excessive pressure if doing so. Now tighten all the mounting points. Check fixings periodically.
Note: The 2 push-rivets supplied are not integral to the fitment of this product, but have been supplied for those customers who would prefer to have mechanical fixing at the point where the two guards meet.
Any questions?
- sales@pyramid-plastics.co.uk +44 (0)1427 677990
- www.pyramid-plastics.co.uk
- Follow us on social media and feel free to leave us a review!
FAQ
Q: Are the push-rivets necessary for installation?
A: The push-rivets supplied are not integral to the fitment of this product but have been provided for customers who prefer to have a mechanical fixing at the point where the two guards meet.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>