PYRAMID GSF650 Suzuki Bandit Belly Pan Instruction Manual
- June 2, 2024
- PYRAMID
Table of Contents
PYRAMID GSF650 Suzuki Bandit Belly Pan
Specifications
Component | Location | Details |
---|---|---|
‘U’ Shaped Brackets | Not Specified | Part of the kit |
Rear Right-hand side Bracket | Right-hand side of bike | Shown in Fig 1 |
Forward Brackets (Handed Pair) | Not Specified | Part of the kit |
FAQ
- Q: Do I need to remove any parts from the standard bike to fit the belly pan?
- A: No, no parts are removed or modified on the standard bike for the installation of the belly pan.
- Q: How can I prevent scratching the bike during installation?
- A: Place cardboard or similar material under the bike, and use electrical insulation tape or similar on the frame down tubes.
- Q: What should I do if I have questions or issues during installation?
- A: Contact Pyramid Plastics at sales@pyramid-plastics.co.uk or call +44 (0)1427 677990. You can also visit their website at www.pyramid-plastics.co.uk for more information.
Kit Includes
- 1X C207036 Moulding
- 2X CFK207036 ‘U’ Shaped Brackets
- 2X “” Forward Brackets (Handed Pair)
- 1X “” Rear Left-hand side Bracket
- 1X “” Rear Right-hand side Bracket
- 2X CBOLM100004 M10 X 50mm Socket Cap Bolts
- 2X CNUTM100003 M10 Flange Head Nuts
- 4X CBOLM60007 M6 X 12mm Button Head Bolts
- 4X CWASM60002 M6 Shake Proof Washers
- 4X CGROM60001 Rubber Grommets
- 4X CSPAM60004 M6 X 8mm Steel Collar
Fitting Instructions
Fitting – NO PARTS ARE REMOVED OR MODIFIED ON THE STANDARD BIKE
- Place cardboard or material under the bike to avoid scratching the Pyramid belly pan during installation. A bike ramp will make installation easier.
- Apply a single layer of electrical insulation tape or something similar to the frame down tubes to avoid scratching the paint.
- Loosely attach four brackets as shown in Fig 1 + Fig 2. The M10 X 50mm socket cap bolts secure the two smaller rear brackets via the pre-drilled holes in the engine casting.
- Now install the four rubber grommets and steel collars into the pre-drilled holes in the Pyramid belly pan.
- Fully tighten the rear brackets (left and right side). Attach the Pyramid belly pan loosely to these brackets.
- With the forward brackets loosely positioned on the frame as shown below, attach the Pyramid belly pan to these brackets.
- Make final adjustments and fully tighten all fasteners – Note: the forward clamp brackets should be tightened last.
- Be sure to check fixings periodically
CONTACT
- sales@pyramid-plastics.co.uk
- +44 (0)1427 677990
- www.pyramid-plastics.co.uk
Follow us on social media and feel free to leave us a review!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>