PYRAMID XT1200Z Super Tenere Extenda Fenda Instruction Manual
- June 2, 2024
- PYRAMID
Table of Contents
PYRAMID XT1200Z Super Tenere Extenda Fenda
Product Information
- Specifications:
- Moulding Brackets: A+B pair
- Black Stainless Steel Bolt: M5 x 12mm
- Stainless Steel Washer: M5
- Stainless Steel Serrated Nut: M5
- Foam Strip: 20mm x 1.5mm (cut to 250mm in length) Push-rivets
Product Usage Instructions
- Attaching the Mudguard
- Loosely attach the mudguard to the brackets using the M5 fixings supplied. Place the M5 stainless steel washers under the bolt head and under the serrated nuts.
- Attaching Foam Strip
- Cut and attach the foam provided in the area marked ‘A’ below.
- Tightening Mounting Points
- Following instructions marked ‘B’ below, be sure to check alignment as you go. Now tighten all the mounting points. Check fixings periodically.
- Installing Extenda Fenda
- Once the brackets are fitted, drill 4mm holes through the OEM mudguard and EXTRA Extenda Fenda. Use the push-rivets supplied to secure the two parts together.
- Brake Caliper Bolt Adjustment
- Remove the brake calliper bolt on each side of the bike. Refit the bolt with the mudguard brackets in place as shown in the manual.
FAQs
- Q: How do I differentiate between Bracket A and Bracket B?
- A: Bracket A is for the left-hand side of the bike, while Bracket B is for the right-hand side of the bike.
- Q: What is the recommended contact for any questions or support?
- A: You can contact sales@pyramid-plastics.co.uk or call +44 (0)1427 677990 for assistance. You can also visit www.pyramid-plastics.co.uk for more information.
- Q: Is there a warranty for this product?
- A: Please refer to the warranty information provided with your purchase or contact customer support for details on product warranties.
Kit Includes
1X | C052101 | Moulding |
---|---|---|
2X | CFK052101 | Brackets (A+B pair) |
4X | CBOLM50005 | M5 X 12mm Black Stainless Steel Bolt |
8X | CWASM50002 | M5 Stainless Steel Washer |
4X | CNUTM50003 | M5 Stainless Steel Serrated Nut |
1X | CFOA0002 | Foam Strip 20mm X 1.5mm (cut to 250mm in length |
)
4X| CRIV0003| Push- rivets
- We advise the use of thread-locking fluid on all the fixings for this product.
- Loosely attach the mudguard to the brackets using the M5 fixings supplied.
- Place the M5 stainless steel washers under the bolt head and the serrated nuts.
- Cut and attach the foam provided in the area marked ‘A’ below.
- Following instructions marked ‘B’ below. Be sure to check alignment as you go!
- Now tighten all the mounting points. Check fixings periodically.
Please note: the brackets supplied appear similar but are different!
- Bracket A = left-hand side of the bike.
- Bracket B = right-hand side of the bike.
CONTACT
- Any questions?
- sales@pyramid-plastics.co.uk.
- +44 (0)1427 677990
- www.pyramid-plastics.co.uk.
- Follow us on social media and feel free to leave us a review!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>