B TECH BT7504 Small Medium Flat Screen Display Trolley Installation Guide
- August 6, 2024
- B-TECH
Table of Contents
BT7504
Small / Medium
Flat Screen Display Trolley
Installation Guide
BT7504 Small Medium Flat Screen Display Trolley
- Recommended for screens up to 55″
- Max load: 25kg (55lbs)
- Designed for displays with VESA* fixings from 75 x ‘75mm up to 400 x 400mm
- Suitable for displaying screens in a landscape or portrait orientation
- Non-marking locking / braked castors included
- Integrated cable management
- Trolley dimensions: H.1634mm W.779mm D.624mm (H.64.4″ W.30.7″ D.24.6″)
Installation Safety Instructions
Caution: this mount is intended for use only with the
maximum weights indicated. Use with equipment heavier than the maximum
indicated may result in instability causing possible injury.
Do not attempt to install this product until all instructions and warnings
have been read and properly understood.
Please keep these instructions for future reference.
Please check carefully to make sure there are no missing or defective parts –
defective parts must never be used.
B-Tech AV Mounts, its distributors and dealers are not liable or responsible
for damage or injury caused by improper installation, improper use or failure
to observe these safety instructions. In such cases, all guarantees will
expire.
General
B-Tech AV Mounts recommends that a professional AV installer or other suitably
qualified person install this product.
Great care must always be taken during installation as most AV equipment is of
a fragile nature, possibly heavy and easily damaged if dropped. If you do not
fully understand the instructions or are not sure how to install this product
safely, then please consult a professional for advice and/or to install this
product for you. Failure to mount this product correctly may cause serious
injury or death both during installation and at any time thereafter. Do not
mount any AV equipment that exceeds the specific weight limit of the product
you are installing. This weight limit will be clearly stated on each product
and its packaging and will vary from product to product.
Trolley Operation
Warning: The trolley can tip over which may lead to serious injury. Only
adults should push this trolley, do not allow children under 16 to move the
trolley. Push the trolley on the narrow side, never pull the trolley. Do not
push at the top of the trolley, push near the middle. Move the trolley slowly.
Always park on level ground, never leave the trolley on an incline.
Apply the brakes when the trolley is stationary, release the brakes when
pushing the trolley
Product location
Please pay careful attention to where this product is located, sorne locations
are not suitable for installation. For indoor use only. Install stand on level
ground. When verifying the stability of the structure, consider the following
external factors:
The strength of the floor, exposure to sudden and severe wind and danger
arising from contact with people and / or objects (eg installations in
passageways, emergency exits), if located in a public or frequently populated
area ensurethat the product is out of the immediate reach of people.
Fixing hardware
It is highly recommended that all fixing screws be used where supplied and
that the purpose of all other fixing hardware is fully understood. In some
cases more AV equipment fixing hardware will be supplied to accommodate
different models of equipment and set up configurations. The installer must be
satisfied that any supplied fixing hardware is suitable for each specific
installation. The fixing kit supplied with the product may not be suitable for
all walls. If any fixing screws or included hardware are deemed not sufficient
for a safe installation then please consult a professional or your local
hardware store.
Hazard limitation
When routing cables take advantage of any built in cable management features
that the product might provide and ensure that all cables are tidy and secure.
Check to see that any moving aspect of the product can do so unhindered by any
cabling.
Some products have moving parts and the potential to cause injury through the
crushing or trapping of fingers or other body parts. Particular attention to
the nature of moving parts is required especially when assembling installing
and adjusting during set up. Immediately after installation double-check that
the work done is safe and secure. Double-check all necessary fixings are
present and are of ample tightness. It is recommended that periodic
inspections of the product and its fixing points are made as frequently as
possible (no more than 6 months apart) to ensure that safety is maintained.
If in doubt consult a professional AV installer or other suitably qualified
person.
B-Tech AV Mounts recommends that this product be installed by a qualified AV
technician or other suitably qualified person. B-Tech AV Mounts, its
distributors and dealers are not liable or responsible for damage or injury
caused by improper installation, improper use or failure to observe these
safety instructions. In such cases, all guarantees will expire.
This product must be mounted on a suitable surface and may only be used up to
the specified maximum weight.
BT’7504 Parts List
Please keep this for future reference
Item | Description | Qty |
---|---|---|
1 | Base | 1 |
2 | Castor | 4 |
3 | Lower Pole | 1 |
4 | Upper Pole | 1 |
5 | Mounting Plate | 1 |
6 | Interface Plate | 1 |
7 | 400mm Adaptor Arm | 4 |
8 | M16 x 55mm Screw | 1 |
9 | M8 x 16mm Screw | 4 |
10 | M6 x lOmm Screw | 8 |
11 | M4 x 6mm Hex Screw | 2 |
12 | M6 Grub Screw | 1 |
13 | 3AF Hex Key | 1 |
14 | 4AF Hex Key | 1 |
15 | 5AF Hex Key | 1 |
16 | 14AF Hex Key | 1 |
Screen Fixings
A| M4 x 12mm Screw| 4
B| M4 x 25mm Screw| 4
C| M6 x 16mm Screw| 4
D| M6 x 25mm Screw| 4
E| M6 x 40mm Screw| 4
F| M8 x 16mm Screw| 4
G| M8 x 25mm Screw| 4
H| M8 x 50mm Screw| 4
I| M4 Washer| 4
7| M6 Washer| 12
K| M8 x 5mm Spacer| 4
L| M8 x 15mm Spacer| 4
M| M8 x 25mm Spacer| 4
Warning
- Can tip over which may lead to serious injury
- Do not allow children under 16 to move the trolley
- Move the trolley slowly
Apply the brakes when trolley is stationary.
Release brakes when pushing trolley.
Never leave the trolley on an incline.
Always park on level ground.
Only adults should push this trolley.
Push trolley on narrow side.
Never pull trolley.
Always push.
Do not push at top of trolley.
Always push near middle.
Installation Instructions
-
Fix Castors To Base
° With the brakes applied, screw item 2 into item 7 -
Assemble Pole
° Connect item 3 to item 4, using item 9. -
Attach Poles To Base
i. Connect items 3 & 4 to item 7 using item 8, and tighten thoroughly. Note: Ensure the Mounting Plate fixing holes are facing forward (for screen mounting).
ii. Important: Secure pole to base by tightening item 12. -
Attach Mounting Plate To Pole
° Choose the desired height for the screen and fix item 5 to item 4 using item -
Important: Tighten thoroughly.
-
Fix Interface Plate To Screen
-
For screens with VESA fixings:
75 x 75, 100 x 100, 200 x 100 or 200 x 200mm Fix itern 6 to the back of the screen using the screen fixing kit (items A-M). Note: Use spacers fiterns K, L & M) on screens with recessed fixings.
For screens with fixings (over VESA 200) up to 400 x 400mm
i. Connect items 7 to itern 6 using item 10.
ii. Fix itern 7 (with item 6 attached) to the rear of the screen using iterns A-M.- Mount Screen and Secure On Trolley
-
i. Hook screen onto item 5.
Note: Ensure castors are braked. ii. Use item 771 to secure item 6 onto item 5.
Note: Thread cables through cable management holes on the back of the poles.
BT7504 Dimensions
Please keep this for future reference
These instructions are intended as a guide only and B-Tech accepts no liability for the accuracy of the information contained in this document.
Contact: info@btechavmounts.com
©2024 B-Tech AV Mounts Corporation Ltd. All rights reserved.
B-Tech AV Mounts is a division of B-Tech AV Mounts Corporation Ltd.
B-Tech AV Mounts and the B-Tech logo are registered trademarks.
All B-Tech images and symbols are exclusive property of B-Tech AV Mounts
Corporation Ltd.
All other brands and product names are trademarks of their respective owners.
Any reproduction, retransmission or republication of any part of this manual
is strictly prohibited,
unless prior written permission has been granted by B-Tech AV Mounts
Corporation Ltd.
Photographs are for illustrative purposes only. E&OE
AMA-BT7504-V1.1-0424-44 Made in the P.R.C.
https://www.btechavmounts.com/product-range/products/bt7504
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>