HYCHIKA HS12K Spring Steel Hole Saws Instruction Manual
- August 15, 2024
- HYCHIKA
Table of Contents
HYCHIKA HS12K Spring Steel Hole Saws
Packing List
-
7-in-1 Hole Saw Kit 26 / 32 / 38 / 45 / 50 156168mm
-
2PCS Installation Plate
1 PC 10mm Drill Bit, 1 PC 6mm Drill Bil
1 PC Hex Key, 1 PC Wrench -
5-in-1 Hole Saw Kit 60/68/74/81195mm
WARNING!
Read tool manual, Wear eye protection. Never operate without pilot bit. Use only in a drill with side assist handle. Before drilling make sure that shank screw is lightened, Start slowly with bit in contact with work. Do not cause misalignment of cup in hole while cutting as this will cause a torque back reaction. Disconnect power before inserting or removing arbor in drill, Check to be sure the area in which you intend to cut into has no live electric wiring!
User Guide
The HYCHIKA Hole Saw Kil deliver precise cuts in a variety of applications. The user simply selects the blade with the desired diameter, inserts and locks it into place, and starts drilling. The deep-cup design provides fast and smooth cutting performance, and it is also suitable for hard wood, soft wood, veneered wood and coated chipboard drilling. The heat-treated high-carbon a hex shank arbor that is compatible with most drill/drivers.
Parts Name
- A. Drill bit
- B. Hole saw blade
- C. Installation plate
- D. Screw
Instructions
- Carefully remove Hole saw form packaging.
- Squeeze the exterior of each hole saw blade(B) and turn counter-clockwise.
- Pull to remove each hole saw blade(B) from installation plate(C).
- After all blades are removed, select the size you would like to use.
- Attach selected blade to the correct diameter groove in the installation plate(C).
- After placing hole saw blade(B) in the groove, turn clockwise to lock it in place.
- Check to make sure the hole saw blade(B) is securely attached to the installation plate(C).
- Before use, make sure that the screw(D) has been tightened and the drill bit(A) will not move up and down.
- Do not attach more than one blade to the installation plate(C) to cut a hole.
- After inserting hole saw assembly into the tool, do not rotate counter-clockwise.
Suggested Speed
7-in-1 Hole Saw RPM Guide | 5-in-1 Hole Saw RPM Guide |
---|---|
Size/mm | Wood |
26 | 2700/min |
32 | 2400/min |
38 | 2100/min |
45 | 2100/min |
50 | 2000/min |
56 | 2000/min |
68 | 1500/min |
Customer Support
If any problems, please contact our after-sales email: support@hychika.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>