newline NT+ Series WiFi Modules Installation Guide

June 10, 2024
newline

newline NT+ Series WiFi Modules

newline-NT-Series-WiFi-Modules-PRODUCT-IMG

Product Information

The NT+ series is a display panel with a built-in Wi-Fi module that can be installed on the rear of the panel to enable wireless connectivity. The Wi-Fi module is designed to work with the NT+ series and should only be installed by a qualified technician.

Product Usage Instructions

To install the Wi-Fi module on the NT+ series, follow these steps:

  1. Power off the display panel and unplug it from the power source.
  2. Remove the Wi-Fi module cover by unscrewing the two screws that secure it to the panel. Save the Wi-Fi module cover and screws if the panel will be transported in its original packaging in the future.
  3. Insert the Wi-Fi module into the open port on the rear of the panel until it is firmly seated. Make sure to insert the Wi-Fi module with the black fins facing outward towards the wall.
  4. Use the new M3*6 screws provided with the Wi-Fi module to secure it to the panel. Do not over tighten the screws.
  5. Replace the Wi-Fi module cover and secure it with the two screws that were removed in step 2.
  6. Power on the display panel and verify that the Wi-Fi module is functioning properly.

Caution: Do not attempt to insert or remove the Wi-Fi module when the display is powered on. Doing so may cause damage to the display or Wi-Fi module. For further assistance, contact our Technical Support Team at 833-469-9520, ext 5000 or email support@newline-interactive.com.

How to Install Wi-Fi Modules

Perform the following steps to install the Wi-Fi Module on the NT+ Series.

Step 1: Remove the Wi-fi module cover by unscrewing the two screws securing the cover to the panel. The Wi-Fi module cover and screws should be saved if the panel will be transported in its original packaging in the future.

Step 2: Insert the Wi-Fi module into the open port on the rear of the panel until it is firmly seated.
Note: Insert the Wi-Fi module with the black fins facing outward towards the wall.

Step 3: Use the new M3*6 screws provided with the Wi-Fi module to secure it to the panel.
Note: Do not over tighten screws.

Caution

The Wi-Fi Module does not support hot plugging. Therefore, you must insert or remove the Wi-Fi Module when the display is powered off. Otherwise, the displays or Wi-Fi Module may be damaged.

Contact Us

Still need additional assistance? Contact our Technical Support Team at 833-469-9520, ext 5000 or support @newline-interactive.com.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals