Motive AutoTap OBD-II Vehicles Installation Guide

June 3, 2024
motive

Motive AutoTap OBD-II Vehicles

Motive-AutoTap-OBD-II-Vehicles-PRODUCT-IMG

Connect the Motive “Vehicle Gateway” to “AutoTap adapter”

Step 1

Plug the male 9-pin connector into the female 9-pin port located on the AutoTap

Step 2

Insert the male 15-pin connector located on the Motive Vehicle Gateway into the 15-pin female end of the cableMotive-AutoTap-OBD-II-Vehicles-FIG-
\(1\)

Connect “Vehicle Gateway + AutoTap” to Vehicle

Step 1

Insert the male 15-pin connector into the opposite side of the AutoTap

Step 2

In the vehicle, verify that the engine is OFF. Then, plug the male OBD-II 16-pin connector into vehicle’s diagnostic port

Step 3

Start the vehicle and let it run. After approximately two minutes, the right- side indicator should start flashing red indicating a successful connection to the vehicle.

Step 4

If the engine is running and the right-side indicator is flashing red, the installation is complete and you may turn off the engine. If the right-side indicator remains solid red (not flashing), recheck the connections, and if necessary, please contact Motive support at 855-434-3564 or support@gomotive.comMotive-AutoTap-OBD-II-Vehicles-
FIG- \(2\)

If you want to install using Y-cable option, there are 3rd party Y-cable options available. Motive OBD-II Y-cable (Cable 3017) does not support this option today. Please reach out to our support team for further details
855-434-3564 | support@gomotive.com
gomotive.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals