CG MOBILE SP-K4 Wireless Headphones User Guide
- July 31, 2024
- CG MOBILE
Table of Contents
CG MOBILE SP-K4 Wireless Headphones User Guide
Description:
Content:
Bluetooth Headphone
Charging Cable Aux-in Cable
Quick Guide
Product Specification
Bluetooth version: V5.3 Transmit distance: 10 meter Battery: 3.7V / 300 mAh
Input: DC 5V / 500 mA Charging Time: 1.5-2 hours Playback Time: 30 hours
Driver Unit: 40mm Sensitivity: 108±3 dB
Impedance: 32 ohm±15% Frequency: 20hz-20Khz
Product Operation
- Bluetooth Pairing:
- For first pairing, press and hold button for 3 seconds, the headphone will indicate Bule light for 2 seconds and enter into pairing mode, than the light will flash in Red and Blue
- Activate the Bluetooth function on your Bluetooth device (phone or music device). Please refer to the manufacturer’s instructions for instructions on enabling Bluetooth on your
- Once you have activated Bluetooth on your device, select the headphone ‘SP-K4’ from the list of available Bluetooth devices.
- When the pairing is successful, Blue light will flash slowly every 5 seconds and your device will show the connected Bluetooth
Note: The pairing function can be different from device to device (check the manual of your device) .
Power on and Power off:
Power on – Press and hold button for 3 seconds.
Power off – Press and hold button for 3 seconds.
Bluetooth music play:
Open the music player, select a song to play, press the buttonto play music
and then press again to pause music. Play music and short press button to
increase the volume,
press and hold for 2 seconds to change the next song.Play music and short
press button to decrease the volume,press and hold for 2 seconds to change the
previous song.
Bluetooth phone call:Press the button to answer an incoming call, press
thebutton again to end the call.
When the call is coming, press the button for 2 seconds toreject the
call.Active Voice Assistant
Double press to active voice assistant (Siri/Google Now…).Charging
When the Bluetooth headphone is connected with charger (orcomputer USB port)
by charging cable, the headphone will indicate Red light. When the headphone
is fully charged, the indicator will be off.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1)
This device may not cause harmful interference, and (2) this device must
accept any Interference received, including Interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to COrrect the interference by one or more of the following
measures: –
Reorient or relocate the receiving antenna. – Increase the separation between
the equipment and receiver. – Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. The device
has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>