PLT UFO LED High Bay Light Owner’s Manual

Table of Contents

PLT UFO LED High Bay Light Owner’s Manual

LED HIGH BAY WARNING, CAUTION, SAFETY AND INSTALLATION INSTRUCTIONS

WARNING

Installation, service, and maintenance of luminaries should be performed by a qualified licensed electrician.
Account for small parts and destroy packing material, as these may be hazardous to children.
Risk of burn. Disconnect power and allow fixture to cool before handing fixture.

CAUTION

Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
Verify that supply voltage is correct by comparing it with the luminaire label information.
All wiring connections should be capped with UL approved wire connectors.
Green ground screw provided in proper location. Do not relocate.
Minimum 90°C supply conductors.

NOTICE

Specifications and dimensions are subject to change without notice.

Installation Instructions

Remove the new LED fixture from the packaging and inspect for any damage. Handle the new LED fixture with care.
CHAIN MOUNT EXAMPLE:
○ Install the chain into the provided wire hanger.
○ Secure the other end of the chain to a structure using hardware that is rated for the load.
○ Install the wire hanger into the side of the top PLTM1 LED channel.
○ Make sure the wiring hangers are fully engaged into the side holes on the top channel.
○ Connect the LED high bay wiring to line wire; black to black, white to white, and green to green. Use only UL listed wiring.
○ *NOTE: Purple and pink lead inside of the driver compartment are 0-10V (low voltage) dimming leads. Connect to dimming low voltage wiring only if desired.
○ Clean all residue and fingerprints from the new LED high bay and lens. Double check all hanging hardware before moving onto the next installation.

Test Switch Indicator Status

Test Switch

Emergency conversion kit will go into emergency mode if test switch is pressed when main supply is on. If not pressed, it will go into charging mode.
In emergency mode, press the test switch for 3 seconds to tum off the current emergency state.

LED Indicator

Emergency Batter Technical Data

Protections

General Wiring Diagram
For Fixed CCT Products

WARNING

Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
To reduce the risk of death, personal injury, or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards, read all warnings and instructions included with and on the fixture box and all fixture labels.
Proper grounding is required to ensure safety.
Power must be turned off at the breaker before installation or maintenance.
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Wear gloves and eye protection at all times while installing, servicing, or performing maintenance on the luminaire, and avoid direct eye exposure to the light source while it is on.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Do not install damaged product. Inspect luminaire for damage that may have occurred during transit. If damaged, contact the manufacturer immediately.
These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, contact the manufacturer.