LASER EPS-KWGLOW-GN Light Up Earphones User Manual
- June 3, 2024
- Laser
Table of Contents
LASER EPS-KWGLOW-GN Light Up Earphones
WHAT’S IN THE BOX
- Earphones
- Charging Cable
- 2 x Sets of Spare Earbuds
- User Manual
SPECIFICATIONS
Earphone Driver Size: 10mm
Impedance: 32Ω
Sensitivity: 96dB +/- 3dB
Frequency Range: 20 – 20,000Hz
Cable Length: 102cm
Battery Capacity: 80mAh
Charging Input: 5V/1A (max)
Charging Time: 30 minutes
PRODUCT DIAGRAM
MULTIFUNCTION BUTTON MEDIA CONTROLS
-
Play/Pause
Tap during music playback. -
Answer Call
Tap during incoming call. -
End Call
Tap during call.
MULTIFUNCTION BUTTON LIGHT CONTROLS
-
Press and hold the multifunction button for two seconds. The light flashes along the cable to turn ON the light function.
When the volume reaches 70% or more during music playback the light on the cable will flash. -
Press and hold the multifunction button for two seconds. The light flashes along the cable 3 times to turn OFF the light function.
CHARGING
- Plug the included USB cable into a 5V/1A charging source.
- The battery will take 30 minutes to charge fully.
Note: The battery is only required for the cable light function. No battery is required to use the earphones.
TROUBLESHOOTING
My device is not detecting the earphones.
- Unplug the earphones and plug back in.
- Try the earphones on another device.
- Check the 3.5mm port you are plugging into is an audio out port.
Visit our website
Check us out at Youtube
www.youtube.com/lasercoau
Thank you for your purchase!
Laser Corporation is 100% Australian-owned & operated. To get the most out of
your product please read the user manual carefully and keep it for future use.
For specific information relating to your product such as Spare Parts, FAQs,
Warranty claims, and more, please scan the following QR code:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>