ATK BLAZING SKY X1 Lightweight Wireless Mouse User Guide
- July 26, 2024
- ATK
Table of Contents
ATK BLAZING SKY X1 Lightweight Wireless Mouse
Introduction
- Type-C Port
- Left Mouse Button
- Right Mouse Button
- Scroll Wheel
- LED FETIT
- Forward Button
- Back Button
- Feet
- Optical Sensor
- DPI Button
- Power Switch
Quick Start
- Charge / Wired Mode
- Wireless Mode
Bluetooth Pairing Instructions
Set the bottom switch to Bluetooth mode, and press and hold the left, middle,
and right buttons for more than 3 seconds simultaneously till the indicator
flashes in blue. Find and connect the device named as ATK X1 PRO (ATK X1 PRO
MAX / ATK X1 ULTRA), the indicator will stop flashing after being paired.
Operate the mouse and enjoy Bluetooth.
DPI Set
Press the DPI button to quickly switch the DPI. The free drive provides the following DPI set and Status ignition.
The DPI can be set between 50 to 36000 DPI by software.
Polling Rate Set
- Set the rate by software
Battery Indication
- Blinking In Red : 10%Battery, please
- Blinking In Yellow : Charging/Atmi: ZE/
- Staying in Green : Charging completed
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. Suppose this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. In that case, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement
- This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
- This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 5mm between the radiator and your body.
Software Download
- WWW.ATK.PRO
- Removal Instruction for Battery Recycling
- As the product is constantly upgraded, CAN SAN the Code to see the latest manual
Specifications
- Model: XYZ-2000
- Dimensions: 10in x 6in x 3in
- Weight: 2 lbs
- Power: 120V AC
- Color: Black
FAQs
Q: How do I change the settings on the XYZ-2000?
A: Use the control knobs to navigate through the menu options and make
adjustments as needed.
Q: Can I use the XYZ-2000 with a different power source?
A: No, the XYZ-2000 is designed to work with a 120V AC power source only.
Do not attempt to use it with a different voltage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>