wuuk BAP01 Baby Camera Monitor User Manual

wuuk BAP01 Baby Camera Monitor

Product Information

Specifications

• Compliance: Part 15 of the FCC Rules
• Interference Conditions: Must not cause harmful interference and must accept any received interference
• Antenna Usage: Must not be co-located with other antennas or transmitters
• RF Exposure: Evaluated to meet general RF exposure requirements

Product Usage Instructions

Compliance with FCC Rules

• Ensure that the device complies with Part 15 of the FCC Rules.
• Do not use the device in a way that may cause harmful interference to other devices.

Interference Management

• Make sure the device can accept any interference it receives. If undesired operation occurs due to interference, take necessary steps to mitigate it.

Antenna Usage

• Avoid co-locating the device and its antenna(s) with any other antennas or transmitters to prevent operational issues.

RF Exposure

• The device has been evaluated for general RF exposure requirements. Use the device in portable exposure conditions without restrictions.

Frequently Asked Questions

Q: What should I do if I encounter interference while using the device?

A: If interference affects the device’s operation, try relocating the device or adjusting its positioning to minimize interference. If the issue persists, contact customer support for further assistance.

Q: Can I modify the device in any way?

A: No, any changes or modifications not approved by the responsible party for compliance could void your authority to operate the equipment. It is recommended to use the device as intended without alterations.

WHAT’S INCLUDED

PRODUCT OVERVIEW

Baby Camera

1. Indicator light
2. Camera lens
3. Microphone
4. SD card slot
5. Speaker
6. SYNC button
7. Power port

Note: Rotate the camera upwards to reveal the SD card slot

Baby Monitor

1. Screen
2. Indicator light
3. Volume control
4. Zoom in/out of control
5. Menu/OK button
6. Navigation buttons
7. Return button
8. Microphone
9. Talk button
10. Speaker
11. Power button
12. SD card slot
13. Antenna
14. Power port
15. Support stand

SETTING UP THE SYSTEM

Fully Charge the Monitor before Use

1. Use the Type C cable of the baby monitor to connect the power adapter.
2. Plug the power adapter into a power outlet.
3. Connect the other end of the baby monitor’s Type C power cable to the Type C port on the monitor for charging.

Indicator Light

• Charging: Blue
• Fully charged: Green

Camera Installation

• Turn On the Monitor: Press and hold the power button for 3 seconds.
• Turn Off the Screen{Sleep Mode): Press the power button once.
• Turn Off the   Monitor: Press and hold the power button for 3 seconds.

1. Attach the Thermometer/Hygrometer to the end of the baby camera’s power port.
2. Attach the Type C power cable of the baby camera to the other end of the Thermometer/Hygrometer.
3. Connect the other end of the Type C power cable to the power adapter (SV 2A) then connect the power adapter to a power outlet.

Understand the Indicator Light

Mounting the Camera On the Wall Mount

To mount the Baby Camera on the wall, follow the steps below:

• Place the locating sticker against the wall and then mark the screw position at which drilling will be required.
• Drill holes with a 6mm drill bit.
• Align the holes on the mounting plate with those in the wall. Insert the anchors into the holes; anchors are necessary for walls that are made out of hard materials such as concrete, brick, or stucco. Fix the screws to fasten the mounting plate to the wall.
• Align the grooves with the mounting plate and rotate the camera clockwise until it clicks into place.

CONNECTING THE CAMERA TO YOUR PHONE OPTIONAL

• Download the WUUK app from the App Store (iOS devices) or Google Play Store (Android devices).
• Register an account if there is no existing account.
• Go to the app homepage. Tap Add Device, and add the WUUK Baby Monitor to your WUUK app.
• Follow the on-screen instructions to complete the setup.

CUSTOMER SERVICE

• For troubleshooting, check the WUUK app >Account> Help Center for more reference and live chat with Customer Support agents if needed.
• Warranty: 12-month Limited Warranty
• Call Us: United States +1 415-881-5715
• Email Us: hello@wuuklabs.com
• WUUK Labs Corp. All rights reserved.
• WUUK and WUUK Logo are trademarks of WUUK Labs Corp., registered in the United States and other countries. All other trademarks are the property of their respective owners.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult a dealer or an experienced radio/TV technician for help.

Declaration of Conformity

• When charging, please place the device in an environment that has a normal room temperature and good ventilation.
• It is recommended to charge the device in an environment with a temperature that ranges from s·c-2s·c.
• Please ensure to use only the charger offered by the manufacturer. Using an unauthorized charger may cause danger and violate the authorization of the device and the guarantee article.
• This charger is for indoor use only.

IC RF Statement

• When using the product, maintain a distance of 20cm from the body to ensure compliance with RF exposure requirements.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference,
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter.

Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirements in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>