Helmholz 700-842-8ES01 8-Port FLEXtra SLIM Ethernet Switch Owner’s Manual
- July 26, 2024
- Helmholz
Table of Contents
Owner’s Manual
700-842-8ES01 8-Port FLEXtra SLIM Ethernet Switch
FLEXtra SLIM Ethernet-Switch 8-Port, unmanaged, 100 Mbps (700-842-8ES01)
Version 1 for HW-Version 1
Application area
The Helmholz „FLEXtra SLIM Ethernet-Switch 8-Port, unmanaged, 100 Mbps“ is
suitable for installation on a DIN rail and connects up to 8 Ethernet
participants with 10 or 100 Mbps. The FLEXtra SLIM EthernetSwitch is suitable
for PROFINET networks.
The LLPD (neighborhood detection) and PTCP (time synchronization) functions
are handled correctly with the switch in accordance with the PROFINET
standard. The FLEXtra SLIM Ethernet-Switch thus complies with PROFINET
Conformance Class A.
Connections
The FLEXtra SLIM Ethernet-Switch has 8 RJ45 connectors (X1 P1 – X1 P8). The
switch must be supplied with 24 V DC at the wide range input “Ext. V DC 18…30
V” via the supplied connector plug.
The connection (FE, ) is for the functional earth. Connect this properly to
the reference potential.
Features
- Store-and-Forward architecture
- 10Base-T/100Base-TX
- Full-/Half-Duplex
- Autonegotiation
- Auto MDI/MDI-X (IEEE 802.3u Auto crossover support)
- LLDP & PTCP Delay-Traffic blocking (for PROFINET networks)
- PROFINET Conformance Class A
- QoS-Priority Queues: 2 per port
- 1K MAC address lookup table
- 448K bits packet buffer memory
- Max. forwarding packet length 1552 bytes
LEDs
PWR Led
On = Power supply present
Off = No voltage or the device is defective
RJ45 LEDs
Orange (Link/Activity): On = Connected Blinks = Data transmission
Green (Speed): On = 100 Mbps Off = 10 Mbps
Attention: If the device is used in a manner not specified by the
manufacturer, the protection provided by the device may be affected. Pay
special attention to the correct contact during cable installation.
If you have problems, always read the latest documentation first, which can be
found on the Internet at www.helmholz.com.
Connected circuits shall meet the requirements of Limited energy circuits acc.
UL61010-1.
Technical data
| Order no. | 700-842-8ES01 |
|---|---|
| Name | FLEXtra SLIM Ethernet-Switch 8-Port, unmanaged, 100 Mbps |
| Scope of delivery | Ethernet 5-port switch with power supply plug, short manual |
| Dimensions (DxWxH) | 35,1 mm x 25mm x 157mm (without connector) |
| Weight | approx. 170g |
| LAN interface (X1) | |
| Number | 8 |
| Connection | RJ45 |
| Transmission rate | 10/100 Mbps |
| Type | 10/100Base-T/TX, Full/Half-Duplex, Autonegotiation, Auto MDI/MDI-X; IEEE |
Auto crossover;
LLDP & PTCP Delay-Traffic blocking (for PROFINET networks)
Status indicator|
Power display| 1 LED, green
Ethernet status| 16 LEDs, orange/green
Power supply|
Voltage supply| 24 V DC (18…30 V DC)
Current draw| max. 75 mA at 24 V DC
Power loss| max. 1,9 W
Ambient conditions|
Ambient temperature| -25 °C … +60 °C
Transport and storage temp.| -40 °C … +85 °C
Relative air humidity| 95% r H without condensation
Pollution degree| 2
Protection rating| IP20
Approvals| CE
Note:
The contents of this document have been checked by us for matching with the
hardware and software described. However, we assume no liability for any
existing differences, as these cannot be fully ruled out. The information in
this document is, however, updated on a regular basis. When using your
purchased products, please make sure to use the latest version of the
document, which can be viewed and downloaded on the Internet at
www.helmholz.de.
Helmholz GmbH & Co. KG
Hannberger Weg 2
91091 Großenseebach
Phone +49 9135 7380-0
Fax +49 9135 7380-490
info@helmholz.de
www.helmholz.de
BT-beipack-197
2024-02-21