InnoGear MT-039 Aromatherapy Diffuser User Manual
- July 26, 2024
- InnoGear
Table of Contents
InnoGear MT-039 Aromatherapy Diffuser
Product Overview
Instruction
Please add half of the water and NO essential oil at the first use, and let it run until auto shut-off.
- Twist upper lid to the right (counterclockwise), and lift it up.
- Connect the included AC adapter to the DC port at the base.
- Add water (no more than 150ml) and a few drops of essential oil into the water tank.
- Align the inner cap nozzle with the mist outlet of lid when installing. Make sure to lock inner cap tightly with the upper lid. Loose inner cap may cause water leakage.
- Put upper lid back on, making sure to point “InnoGear” logo right above the mist and light button and align the groove inside the lid with bulge on the base. Twist to the left (clockwise) to lock the lid.
- MIST button
- Press MIST and the LED indicator turns green. The diffuser begins to work in intermittent mist mode (30 seconds on and off).
- Press MIST again and red LED indicator turns red, and the diffuser changes to continuous mist mode.
- Hold MIST for 3 seconds to turn off the diffuser.
- LIGHT button
- Press once to turn on the light and it will cycle through colors.
- The color will change per press.
- Hold for 3 seconds to turn off the light.
Installation
- Make sure to align the inner cap nozzle with the mist outlet of upper lid and lock tightly.
- 1 Make sure to point the “InnoGear” logo right above the mist and light button.
- 2 Make sure to align the groove inside the lid with the bulge on the base.
- Twist to the left (clockwise) to lock the lid.
Make sure to lock built-in cap tightly with the upper lid.
Troubleshooting
Cannot turn on
| Is there enough water in the tank?
–Please add enough water but do not exceed the MAX line. Is the AC adapter connected correctly?
–Please unplug. check and re-plug correctly.
---|---
No mist or low mist| No enough water or too much water?
–Add the right amount of water but do not exceed the MAX line. Dust on the ultrasonic film?
–Clean the product according to the maintenance.
Upper lid and inner cap installed improperly?
–Remove and re-install properly referring to “Installation·· section. Dust on the air intake?
–If the air intake is dirty, mist will not come out. Just clean it.
Water leakage| Is there any crack at the bottom of the water tank?
–Please check if there is any tiny crack at the bottom of the diffuser through which water can leak. If you find a crack upon receipt of this product. please contact us for a free replacement. Is steam water inside the lid wiped out?
–Wipe out steam water after each use, making sure the inner cap is completely dry before refilling in case steam water may leak out when putting lid back on.
Upper lid and inner cap installed improperly?
–Remove and re-install properly referring to “Installation” section. Low temperature or high humidity?
–In this case, mist may condense quickly into water drops.
-
Q: Can’t open the upper lid?
A: Please point “InnoGear” logo right above the mist and light buttons and align the groove inside the lid with the bulge on the base. Twist to the right (counter-clockwise). -
Q: Diffuser bottom base melted after a few months of use?
A: Chemical essential oils are corrosive to plastic, please use 100% pure essential oils only. Contact us for a replacement/ refund. -
Q: Why can’t | smell anything?
A: The strength of scent from different essential oils may vary. Choose a strong scented oil and don’t put the diffuser near the air conditioner, fan or window. -
Q: Can the lights be set for one specific color only?
A: Yes. Just press the LIGHT button. -
Q: Can I turn off the diffuser by pressing the MIST button?
A: Yes. Hold the MIST button, and both the light and mist will turn off. -
Q: Can I turn the lights off and just use the mist?
A: Yes. There are separate buttons for the light and the mist.
Precaution
- To prolong the life span of the diffuser, do not use mineral water.
- Do not exceed the MAX line when filling water.
- Do not open the upper lid during operation. Please turn off the diffuser first, otherwise the water and oil will splash and oil may stick to the outside of the tank which may make the upper lid harder to open in later use.
- It’s normal that the amount and intensity of the mist change during operation.
- There are many factors that may affect the mist including: water type, humidity, capacity, temperature, and air currents.
- If diffuser runs out of water, it will shut off automatically.
Warning
- Only use 100% pure essential oil with this diffuser. Do not use low quality oil that contains chemicals, spices, or impurities.
- Do not open the cap while your diffuser is running.
- Clean your diffuser every 3 times of use.
Maintenance
- Turn off the power, unplug the power cord, and remove the upper lid.
- Pour out all the remaining water in the tank from the DRAIN SIDE.
- Put a few drops of neutral detergent used in kitchen into warm water and clean the product with a soft rag.
- If the unit happens to be knocked over or tipped during operation, please shake the unit to drain the water inside the mechanism and put it in a well-ventilated place for natural drying.
Specification
| Size | Diameter 106 x Height 147mm |
|---|---|
| Weight | About 348g |
| Input | AC 100-240V 50/60HZ |
| Output | DC 24V |
| Electric wire length | About 170CM |
| Power | About 10W |
| Water tank capacity | 150ML |
| LED quantity | Three |
| Raw material | pp |
| Accessories | Power, measuring cup and user manual |
| Ultrasonic frequency | 2.4MHz |
After-sale Service
This product is guaranteed for 12 months from the date of purchase, please contact us if you need a replacement/refund.
- Email: support@innogear.net
- Phone: 800-806-3008
- Follow us on Facebookwww.facebook.com/InnoGear.net
FAQs
What is the primary function of the InnoGear MT-039 Aromatherapy Diffuser?
The primary function of the InnoGear MT-039 Aromatherapy Diffuser is to disperse essential oils into the air, providing both aromatic and humidifying benefits to create a relaxing atmosphere.
How does the InnoGear MT-039 Aromatherapy Diffuser operate?
The InnoGear MT-039 Aromatherapy Diffuser operates using ultrasonic technology to create a fine mist of water and essential oils, which is then dispersed into the air.
What is the capacity of the water tank in the InnoGear MT-039 Aromatherapy Diffuser?
The InnoGear MT-039 Aromatherapy Diffuser has a water tank capacity of 100 ml.
The InnoGear MT-039 Aromatherapy Diffuser offers two misting modes: continuous mist and intermittent mist.
How long can the InnoGear MT-039 Aromatherapy Diffuser run on intermittent mist mode?
On intermittent mist mode, the InnoGear MT-039 Aromatherapy Diffuser can run for approximately 6-8 hours.
What is the noise level of the InnoGear MT-039 Aromatherapy Diffuser?
The InnoGear MT-039 Aromatherapy Diffuser operates at a noise level lower than 23 dB, making it very quiet.
What safety feature does the InnoGear MT-039 Aromatherapy Diffuser include?
The InnoGear MT-039 Aromatherapy Diffuser includes a waterless auto-off feature that automatically shuts off the unit when the water runs out.
How many LED color options are available on the InnoGear MT-039 Aromatherapy Diffuser?
The InnoGear MT-039 Aromatherapy Diffuser features a 7-color LED light system.
What is the maximum room size the InnoGear MT-039 Aromatherapy Diffuser can cover effectively?
The InnoGear MT-039 Aromatherapy Diffuser can effectively cover a room size of 100-250 square feet.
What is the power source for the InnoGear MT-039 Aromatherapy Diffuser?
The InnoGear MT-039 Aromatherapy Diffuser is powered by an AC adapter, which is included in the package.
How do you clean the InnoGear MT-039 Aromatherapy Diffuser?
To clean the InnoGear MT-039 Aromatherapy Diffuser, use a mild detergent and a soft cloth. For descaling, a mixture of water and white vinegar can be used.
What materials are used in the construction of the InnoGear MT-039 Aromatherapy Diffuser?
The InnoGear MT-039 Aromatherapy Diffuser is made from BPA-free polypropylene (PP) materials.
Is the InnoGear MT-039 suitable for large rooms?
The search results do not provide information on the room size the InnoGear MT-039 is suitable for.
Download this Manual:InnoGear MT-039 Aromatherapy Diffuser User Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>