little tikes 639548 2 in 1 Pop n Pitch Trainer Installation Guide

: July 24, 2024
: Little Tikes

Table of Contents

CONTENTS
REPLACING THE BATTERIES
BATTERY SAFETY INFORMATION
IMPORTANT INFORMATION
FUNCTIONS
ASSEMBLY INSTRUCTIONS
QUICK START
ANGLE ADJUSTMENT
FCC COMPLIANCE
LIMITED WARRANTY
CUSTOMERS SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

little tikes 639548 2 in 1 Pop n Pitch Trainer

little tikes 639548 2 in 1 Pop n Pitch Trainer

REPLACING THE BATTERIES

Before assembly, it is recommended an adult install fresh alkaline batteries in the unit. Here’s how:

Using a Phillips screwdriver (not included) remove the screw and battery compartment cover from under the unit.
Install four (4) 1.5V AA (LR6) alkaline batteries (not included) making sure the (+) and (-) ends face the proper direction as indicated inside the battery compartment.
Replace the compartment cover and tighten the screw.

WARNING!

ADULT ASSEMBLY REQUIRED.
This product is intended for use by children ages 3 years and up.
Do not allow children to sit, stand, play or climb on the unit.
Use product on a firm, level surface.
Do not put your hand inside the product.

BATTERY SAFETY INFORMATION

Use only size “AA” (LR6) alkaline batteries (4 required).
Charging of rechargeable batteries should only be done under adult supervision.
Remove rechargeable batteries from the product before recharging.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
Be sure to insert the batteries correctly and follow the toy and battery manufacturer’s instructions.
Always remove exhausted or dead batteries from the product.
Dispose of dead batteries properly: do not burn or bury them.
Do not attempt to recharge non-rechargeable batteries.
Avoid short-circuiting battery terminals.
Remove batteries before placing the unit into storage for a prolonged period of time.

IMPORTANT INFORMATION

Adult supervision required.
Only one batter at a time.
Recommend or encourage use of a batting helmet to promote safety.
This product is intended for outdoor use only.
Do not place hands, fingers or face near or on the unit.
Do not expose the unit to moisture of any kind. Wipe the unit with a damp cloth, if needed.
Do not use any other objects other than the balls provided with this unit.
Never hit ball at other children, people, animals or moving bicycles.
Never swing bat at others or at other objects.
Do not use product when raining or when ground is wet.
Never place unit on a hard surface such as concrete, asphalt, wood or other hard surfaces. Falls on hard surfaces could result in head or serious injuries.
Avoid placing or using unit in or near swimming pools, on or near steps, hills or inclines.
Avoid placing or using unit in or near street, sidewalks, alleys, patios, hills or garage.
Avoid placing or using unit near playgroud equipment, low branches, wires, clothesline, fences or low bearing branches

FUNCTIONS

Before playing, move the switch from the OFF (O) position to the ON (I) position.
When the unit is turned ON, the sensor will not activate if there are not any baseballs in the basket.
Press the start button with baseballs loaded to activate the unit; the baseballs will automatically be pitched.
In case the unit is turned off in the middle of a previous pitch cycle, when powering the unit on again it may run through a pitch cycle to ‘reset’ itself to the start position.

ASSEMBLY INSTRUCTIONS

Twist the top of the bat into the handle and tighten clockwise.
Twist counterclockwise to separate the top and bottom.
Press the baseball basket onto the pitcher trainer unit until it snaps into place
(Please note: this is a one-time snap; the pieces are not intended to be removed once placed).
Align the two pieces of the chute along the rim of the pitcher trainer unit. Snap both sides together to connect (Please note: this is a one-time snap; the pieces are not intended to be removed once placed).

QUICK START

Place the amount of baseballs in the basket that you want pitched (Note: Place baseballs on the side storage spaces when not in use or if you do not want all baseballs pitched at once).
Press the start button. Then, the pitcher trainer unit and sensor will activate.
The time ball release will automatically pitch the baseballs about every 8 seconds. The unit will ding indicating each pitch.

ANGLE ADJUSTMENT

Turn the chute around clockwise to adjust the angle for longer distance pitches.
Repeat steps 1 & 2 from the ‘Quick Start’ section. The time ball release will automatically pitch the baseballs about every 8 seconds. The unit will ding indicating the next pitch.

FCC COMPLIANCE

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different than that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Caution: Modifications not authorized by the manufacturer may void user’s authority to operate this device. CAN ICES-3 (B)/NMB-3(B).

LIMITED WARRANTY

The Little Tikes Company makes fun, high quality toys. We warrant to the original purchaser that this product is free of defects in materials or workmanship for one year from the date of purchase (dated sales receipt is required for proof of purchase). At the sole election of The Little
Tikes Company, the only remedies available under this warranty will be the replacement of the defective part or replacement of the product.
This warranty is valid only if the product has been assembled and maintained per the instructions. This warranty does not cover abuse, accident, cosmetic issues such as fading or scratches from normal wear, or any other cause not arising from defects in material and workmanship. The warranty period is three (3) months for daycare or commercial purchasers. U.S.A and Canada: For warranty service or replacement part information, please visit our website at www.littletikes.com, call 1-800-321-0183 or write to: Consumer Service, The Little Tikes Company, 2180 Barlow Road, Hudson OH 44236, U.S.A. Some replacement parts may be available for purchase after warranty expires—contact us for details. Outside U.S.A and Canada: Contact place of purchase for warranty service. This warranty gives you specific legal rights, and you may also have other rights, which vary from country/state to country/state. Some countries/states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

‘Let’s care for the environment!’
The wheelie bin symbol indicates that the product and its batteries must not be disposed of with other household waste. Please use designated collection points or recycling facilities when disposing of the item.

Please keep this manual as it contains important information.
Illustrations are for reference only. Styles may vary from actual contents.

© The Little Tikes Company, an MGA Entertainment company. LITTLE TIKES® is a trademark of Little Tikes in the U.S. and other countries. All logos, names, characters, likenesses, images, slogans, and packaging appearance are the property of Little Tikes.
Printed in China

CUSTOMERS SUPPORT

Warranty Icon

US/CA – Little Tikes Consumer Service
2180 Barlow Road, Hudson, Ohio 44236 U.S.A.
Phone: 1-800-321-0183
blog.littletikes.com/little-tikes-contact-form

UK – MGA Entertainment UK Ltd.
50 Presley Way, Crownhill, Milton Keynes,
MK8 0ES, Bucks, UK.
Little Tikes Consumer Services
P.O. Box 2040 Hockley, Essex, SS5 4BF
Phone: 0 800 521 558
E-mail: support@littletikesstore.co.uk

EU – MGA Entertainment (Netherlands) B.V. Baronie 68-70, 2404 XG, Alphen a/d Rijn, The Netherlands
Tel: +31-172-758-010
Email: klantenservice@mgae.com

AU/NZ – Imported by MGA Entertainment Australia Pty Ltd.
Suite 5.05, 32 Delhi Road, Macquarie Park NSW 2113. AU.
Tel: 1 300 059 676
Email: au-sales@mgae.com

Logo
www.littletikes.com
www.littletikes.co.uk
www.littletikes.com.au