Schreder ONYX2 Circle LED Base Installation Guide

Schreder ONYX2 Circle LED Base

Product Specifications

• Product Name: CIRCLE LED BASE 1&2 for ONYX2
• Dimensions: 387mm x 182mm x 282.8mm
• Weight: 132mm x 141.8mm x 372mm x 198.8mm
• Manufacturer: Schreder
• Model: ONYX2 with CLB1*
• Adaptation Plate Size: Same dimensions for CLB2 (cut-out differs)

Product Usage Instructions

1. Disconnect the luminaire from the network and clean the surface.
2. Open the lock on the side of the luminaire and then open it for gear compartment and light source access.
3. Disconnect mains.
4. Remove the original light source.
5. Release screws from the gear plate using PZ2 4xM5.
6. Remove gear plate with ballast from the luminaire using PZ2 2xM5.
7. Remove screws from the optical compartment and keep them for later use.
8. Place the CLB adaptation plate into the luminaire ensuring that the sticker faces the right direction.
9. Fasten the adaptation plate with screws using PZ2 (tightening torque: 2Nm).
10. Connect the earthing cable of the adaptation plate to the luminaire body and connect mains cable to CLB unit.
11. Close the lock on the side of the luminaire.
12. Connect the assembly back to the network.

Frequently Asked Questions (FAQ)
Q: Can I use CLB2 with ONYX2?
A: Yes, CLB2 is also available for ONYX2 with the same adaptation plate size dimensions, only the cut-out i different.

INSTALLATION INSTRUCTIONS

All the tightening torques

**ONYX2 WITH CLB1***

*CLB2 is also available for ONYX2, with the same adaptation plate size dimensions (only the cut-out being different)

1. Disconnect the luminaire from network and clean the surface

2. Open the lock on the side of the luminaire, then open the luminaire for gear compartment and light source access

3. Disconnect mains

4. Remove the original light source

5. Release screws from gear plate

6. Remove gear plate with ballast from the luminaire
   

7. Remove screws from the optical compartment
   KEEP THESE FOR LATER USE!

8. Remove optical compartment

9. Place CLB adaptation plate into the luminaire
   Make sure that the sticker faces the right direction!

10. Fasten the adaptation plate with screws (tightening torque: 2Nm)

11. Connect earthing cable of the adaptation plate to luminaire body
    Connect mains cable to CLB unit

12. Close the lock on the side of the luminaire

13. Connect the assembly back on network

www.schreder.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>