EASYmaxx 11065 Solar Strahler 2 Fach Double Solar Spotlight Instruction Manual

EASYmaxx 11065 Solar Strahler 2 Fach Double Solar Spotlight

Product Information

The Solar-Strahler 2-fach Double Solar Spotlight is a  solar-powered lighting device designed to provide outdoor illumination. It comes with model number RL-11911S and article number 11065. The device is equipped with a Li-ion battery with a capacity of 1200mAh, and it has a motion sensor that can detect movement within 3 to 5 meters. The device has an IP44 rating, which makes it suitable for outdoor use.

Technical Information

• Power Supply: The device is powered by a 3.7 V DC Li-ion battery with a capacity of 1200mAh.
• Lighting Time: The device can provide illumination for approximately 20 seconds when the motion sensor is triggered and up to 1 hour with a fully charged battery.
• Motion Sensor: The device’s motion sensor can detect movement within a range of 3 to 5 meters.
• IP Rating: The device has an IP44 rating, which makes it suitable for outdoor use.

Usage Instructions

1. Before using the product for the first time, read through the operating instructions carefully and keep them for future reference.
2. Check the items supplied for completeness and the product for transport damage. If you find any damage, do not use the product, but contact the customer service department.
3. Remove any films, stickers, or transport protection from the product before use, but do not remove the rating plate and any possible warnings.
4. To mount the device, use suitable fixing materials and make sure there are no pipes or wires behind the intended drilling point.
5. Remove the device’s battery from its compartment and dispose of it properly when it reaches the end of its life cycle.
6. The device is not a toy, and children and pets must not be left unsupervised around it to avoid any injuries.

Customer Service

If you have any questions about the product or need spare parts or accessories, contact the customer service department via the website www.ds- group.de/kundenservice.

Dear Customer
We are delighted that you have chosen our double solar spotlight. If you have any questions about the product and about spare parts/accessories, please contact the customer service department via our website: www.ds- group.de/kundenservice Information About the Operating Instructions Before using the product for the first time, please read through these operating instructions carefully and keep them for future reference and other users. They form an integral part of the product. The manufacturer and importer do not accept any liability if the information in these operating instructions is not complied with.

SYMBOLS

• Danger symbol: This symbol indicates possible hazards. Read the associated safety notices carefully and follow them.
• Direct current
• Read the operating instructions before use!
• Supplementary information

SIGNAL WORDS

Signal words indicate hazards if the associated notices are not followed.
WARNING: medium risk, may result in serious injury or death

ITEMS SUPPLIED

• 1 x double solar spotlight
• 1 x fixings (2 x screws, 2 x anchors)
• 1 x operating instructions

Check the items supplied for completeness and the product for transport damage. If you find any damage, do not use the product but contact our customer service department. Remove any possible films, stickers, or transport protection from the product. Never remove the rating plate and any possible warnings!

TECHNICAL DATA

• Article number: 11065
• Model number: RL-11911S
• Power supply: 3.7 V DC (Li-ion battery, 1200 mAh)
• Battery charge time: approx. 8 – 12 hours (in the sunshine)
• Lighting time: approx. 20 sec. (motion sensor) max. approx. 1 hour (with a fully charged battery)
• Motion capture: approx. 3 to 5 m
• Operating temperature: -20 to +70°C
• Type of protection: IP44
• The ID of operating instructions: Z 11065 M DS V1 1122 as

INTENDED USE

• The product is used for briefly lighting outdoor areas when it is dark using a motion sensor. The battery charges up in daylight via the solar panels.
• The product is designed for personal use only and is not intended for commercial applications.
• The product should only be used as described in the operating instructions. Any other use is deemed to be improper.

SAFETY NOTICES

• Keep the packaging material away from children and animals. There is a danger of suffocation!
• The product is not a toy. Do not leave children and animals unsupervised in order to avoid injuries!
• If the battery has leaked, do not allow your skin, eyes, and mucous membranes to come into contact with the battery acid. There is a danger of burns from battery acid! If you touch battery acid, rinse the affected areas with abundant clear water straight away and seek medical assistance immediately.
• Protect the product from fire, heat sources, and impacts.
• Never immerse the product in water or other liquids! It is only resistant to splashing.
• During extreme weather conditions (e.g. storm, hail) or if it is not going to be used for a long time, switch off the product and store it in a dry place.
• Do not make any modifications to the product. Do not take the product apart and do not attempt to repair it. Contact the customer service department if there is any damage.
• The individual LEDs cannot be replaced.

AT A GLANCE

1. Lamp head with rotary joint (rotatable by 335° each)
2. Solar panel with twilight sensor
3. Wall mounting bracket
4. On/Off switch
5. Motion sensor
6. LEDs (under the cover)
7. Holes for fixing (back)
8. Battery compartment cover (back)

MOUNTING

Please Note

• Use suitable fixings for mounting. If you are unsure whether the fixings included are suitable, seek advice from a specialist stockist.
• Before drilling, ensure that there are no pipes or cables behind the intended drilling point.
• A spirit level, a drill, a hammer if necessary, a screwdriver, and a pen are required for mounting.
• The product should not be placed near to other light sources such as street lamps or other lamps, so that the LEDs can be switched on automatically.
• Place the product in a location where the solar panels can absorb direct sunlight all day long if possible. Fix on a dry, elevated, and even surface.

To mount the product on a wall using the fixings that are supplied, perform the following steps:

1. Use a spirit level and a pen to mark out 2 drilling points.
2. Drill the holes (Ø 6 mm).
3. Insert the anchors into the drill holes. Tap in gently with a hammer if necessary.
4. Turn the screws into the anchors using a screwdriver. Do not screw the screws all the way in.
5. Place the holes (7) on the screw heads and gently press down the wall mounting bracket (3) if necessary. When you do this, make sure that the holes are aligned correctly (see picture).

USE

• Press the On / Off switch (4) to switch on the product and to activate the motion sensor (5) and the twilight sensor.
• When the product is switched on, the battery can charge up in daylight via the solar panels (2). When darkness sets in, the motion sensor is automatically activated and the LEDs switch on for approx. 20 seconds as soon as any movement is detected.
• To check whether the product is switched on during daylight: Cover up the solar panels with one hand and use your other hand to trigger the motion sensor. If the LEDs light up, the product is switched on.
• Twist the lamp heads (1) to align them at the angle you want. The solar panels should be aligned so that they can absorb direct sunlight.
• If it is not being used for a prolonged period, press the On / Off switch to switch off the product. Please Note: The battery performance may be severely restricted in temperatures well below freezing.

CLEANING & STORAGE

• Do not use any caustic or abrasive cleaning agents to clean the product! These might damage the surface.
• Keep the solar panels clean so that the greatest possible absorption of light is ensured. Wipe down the solar panels (and if necessary also the remaining components of the product) with a damp cloth.
• When it is not in use, you should store the product in a dry, clean location that is out of the reach of children and animals.

DISPOSAL

Dispose of the packaging material in an environmentally friendly manner so that it can be recycled. The adjacent symbol (crossed-out bin underlined) means that used devices should not be disposed of in the domestic waste, but should instead be taken to special collection and return systems. Owners of used devices must remove from the user device any used batteries or rechargeable batteries which are not encapsulated by the user device and can be removed in a non-destructive way and disposed of them separately (see also the section on battery disposal). Owners of used devices from private households can take them free of charge to the collection points of the public waste disposal authorities or the disposal points which are set up by manufacturers and distributors under the Electrical Equipment Act. Businesses that market electrical and electronic devices are also obliged to take back used devices.
Non-rechargeable and rechargeable batteries must not be disposed of along with household waste. Consumers are legally obliged to separate and recycle non- rechargeable and rechargeable batteries. Non-rechargeable and rechargeable batteries can be taken free of charge to a collection point of your local authority/district or in shops so that they can be disposed of in an environmentally friendly way and valuable raw materials can be recovered. If they are not disposed of properly, toxic ingredients may enter the environment and have harmful effects on people, animals, and plants. Only dispose of non- rechargeable and rechargeable batteries when they are discharged. With non- rechargeable and rechargeable batteries that contain lithium, cover the poles before disposing of them to prevent a short circuit. A short circuit may cause a fire or explosion.

Removing the Battery

Please Note!

• WARNING! The battery can be deadly if swallowed. The battery and the product should be kept out of the reach of children and animals. There is a danger of burns from battery acid! If the battery is swallowed, medical attention must be sought immediately.
• WARNING! Batteries must not be taken apart, thrown into a fire, immersed in liquids or exposed to high temperatures of over +40°C. The battery could ignite or explode.
• Undo the screws on the battery compartment cover (8) and remove the cover from the wall mounting bracket (3).
• Remove the battery from the battery compartment and dispose of it.

Customer Service

• Tel.: +49 38851 314650
• Calls to German landlines are subject to your provider’s charges.

References

• DS Group - Kundenservice, Kontakt, Produktinformationen

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>