HANECO PURO G4 Oyster Light Installation Guide

HANECO PURO G4 Oyster Light

Specifications

IP54
PURO14W-300R-MS| 9W / 12W / 18W| N/A| 220-240V, 50/60Hz| IP54

Installation Instructions

1. Switch OFF the main power supply.
2. Drill installation holes in ceilings.
3. Install 3 drywall anchors.
4. Run the power cord through the central hole of the base and screw the base to the ceiling. Do not touch LED Chips during this step.
5. Dip the switches to the required sensor, power, and color temperature settings.
6. Connect the power cord to the terminals as shown in the diagram.
7. Reattach cover.

Thanks for choosing our PURO G4 oyster light products.
We strongly recommend you read this guide carefully before installation.

WARNING

• The luminaire must be installed by a licensed/qualified electrician by local wiring and relevant Australian standards.
• Ensure to disconnect the mains supply before conducting any installation and maintenance of the luminaire.
• Ensure input voltage conforms to the voltage range of the product.
• Ensure all the wiring is correct and secured before connecting main supply to the luminaire.
• The warranty is void if the product is not installed according to the instructions
• The light source contained in this luminaire shall only be replaced by the manufacturer his service agent or a similar qualified person.

Note: Product technical information and specifications may ~ change over time without prior notice. For the latest information,
please contact our customer service or visit our website www.honeco.com.au

Product Specifications

Installation Instructions

1. Switch OFF the main power supply.

2. Drill installation holes in ceilings

3. Install 3 drywall anchors.

4. Run the power cord through the central hole of the base and screw the base to the ceiling. Do not touch LED Chips while performing this step.

5. Dip the switches to the required sensor*, power, and color temperature settings.
   For Sensor Version

6. Connect the power cord to the terminals as shown in the diagram.

7. Reattach cover.

• Switch OFF main power supply.

Product Code

• PURO11W- 250R
• PURO14W- 300R
• PURO14W- 300R-MS
• PURO18W- 350R
• PURO18W- 350R-MS
• PURO24W- 400R
• PURO24W- 400R-MS

For more information www.haneco.com.au 1300 001 LED

FAQ

• Q: Can I replace the light source myself?
  • A: The light source contained in this luminaire should only be replaced by the manufacturer, his service agent, or a qualified person.
• Q: What is the default setting for power settings?
  • A: The default setting includes a detection range of 50%, hold time of 3 min, and daylight disabled. You can adjust these settings as needed.

References

• Haneco LED Lighting - Residential & Commercial Lighting | Australia

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>