retrotec Solo Single Channel Manometer User Guide
- July 25, 2024
- retrotec
Table of Contents
Retrotec’s Solo
Single Channel Manometer
Quick Guide
Unpack & charge
□ Remove the gauge, tubes, & charging cable from the packaging.
□ Connect the charging cable to a power supply (5V/3A USB-C Wall Charger).
□ Allow the gauge to charge for a minimum of 2 hours to achieve a full battery
charge.
Turning Gauge On/Off
□ To power on the Solo, press and release the power button located below the
display.
□ To power off the Solo, press and hold the power button for 5 seconds.
Set units
□ To adjust the units displayed on the gauge, press the menu button. The gauge will cycle through available units.
Change Time Averaging
□ Press and hold the menu button for 5 seconds to access the time averaging
settings.
□ Use short clicks of the menu button to scroll through the options.
□ When the [Time Avg] option is highlighted, press and hold the menu button to
select it.
□ Once selected, use short clicks to cycle through available time averaging
intervals.
□ Press and hold menu again to select your desired time interval and then
scroll to exit and long hold to return to the main screen.
Connect Tubing
□ The Solo features two ports on its bottom. The blue port is for connection
to the space from which pressure readings are desired. □ The red port is
either connected via tubing or left open to serve as the reference pressure
for the blue port.
Below are examples of common scenarios for using Solo. This list is not
exhaustive. For assistance with scenarios not listed here, contact Retrotec
Support at 888-330-1345 or via email at
support@retrotec.com.
Zonal Pressure Diagnostics (ZPD):
Blue port connected to zone being measured.
Red port open to the rest of the building.
Pressure Pan:
Blue port connected to pressure pan.
Red port open to the rest of the building.
Flow Box:
Blue port connected to Flow Box.
Red port open to the rest of the building.
Total External Static Pressure (TESP):
Blue port connected to return duct before blower motor.
Red port connected to supply duct after blower motor.
House Pressure:
Blue port open to inside the house.
Red port connected to outside the house
www.retrotec.com
Support: 888-330-1345
International: 1 855-738-7683
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>