horizont AN800D 23 V WiFi Energiser Turbomax Installation Guide
- July 16, 2024
- Horizont
Table of Contents
horizont AN800D 23 V WiFi Energiser Turbomax Installation Guide
Installation
Please read through before installation. Please read safety guidelines leaflet.
ASSEMBLY: Install the energiser on an inside wall, a weatherproof box or within a dry environment.
POWER SUPPLY: Use the enclosed connection cable to guarantee the power supply. For 230 V operation, you must connect the electric fence energizer to a power source using the power supply unit (no. 9). The power supply unit is connected to the device via the connector plug (no. 7). For 12V operation, the power supply must be ensured via a connected 12 V battery. To do this, the connection terminals (no. 8) must be connected to the connecting plug (no. 7) and the battery (red-plus pole, black-minus pole).
Overview
- Status display (LED red)
- Energiser OK display (LED green)
- Fence connection (high power)
- Fence connection (low power)
- Ground connection.
- LC-display
- Connection
- Batterie connection cable
- Power supply unit
- On-/Off-Switch
- Fence connection lead
- Ground connection lead
FENCE CONNECTION: Connect the ring terminals of the earth (no. 12) and
fence connection cables (no. 11) to the respective colored edge nuts (no. 3,4
and 5) to connect them to the energizer. The fence positive + terminal is then
connected to the live fence line and the earthing terminal to the earthing
point.
START-UP: Press the button (no. 10) on the front panel to switch the device on and off. The LCD will then switch on. If you want to use the Wi-Fi function of the device, make sure that the electric fence is within the signal range of a Wi-Fi network. You will also need the horizont fences app from the Play Store or App Store.
To obtain the SAFETY INSTRUCTIONS or the complete operating instructions,
please scan the QR codes shown.
Safety instruction
**Download horizont fences app
**
