Govee H6009 WiFi Bluetooth RGBWW LED Bulb User Manual

Govee H6009 WiFi Bluetooth RGBWW LED Bulb

Safety Instructions

Read and follow all the safety instructions:

• The bulb is not waterproof. Avoid exposing it to splashing or dripping water.
• The operating temperature should be within -100 to 400C (140 to 1040F).
• The bulb’s internal light source is unfixable. If it breaks, you must replace the entire bulb.
• Do not allow children to install the bulb alone.
• Do not install the bulb with a dimming driver. Bulb dims via app control and will not operate with a dimmer switch.
• Do not install the bulb in totally enclosed lurrunanes.
• Avoid installing the bulb near heat sources or in damp locations.
• Avoid installing the bulb near potentially dangerous sources (e.g., candles, liquid-filled Objects).

Introduction

Thanks for choosing Govee Smart LED Bulb. The LED bulb connects quickly to your smartphone in just a few simple steps. Create the warm, vibrant atmosphere you need at the touch of a button.

At a Glance

Installing Your Bulb

Screw the bulb into base.
Notice: Switch off the power switch controlling the bulb before installing.

• PIease wait for a few minutes after using before touching the bulb.

Pairing Your Bulb with the Govee Home App

What You Need:

• A Wi-Fi router supporting the 2.4GHz and 802.11 b/g/n bands. 5GHz is not supported.

• A smartphone or tablet running iOS 8.0 (or above) or Android 4.3 (or above).

• Download the Govee Home app from the App Store (iOS devices) or Google Play (Android devices).
  Turn on the Bluetooth in your smartphone.

• Open the app, tap “+” icon in the top right corner and search “H6009”.

• Tap the device icon and follow the on-screen instructions to complete pairing.

Controlling the Bulb with Your Voice

• Open the Govee Home app, then tap the device icon to enter the details page.
• Tap the “setting” icon in the top right corner.
• Select “Using Guidance” and follow the on-screen instructions to begin using voice control.

Specifications

Troubleshooting

1. Cannot connect the bulb to Govee Home.

   • Check whether the bulb is powered on.
   • Check whether your smartphone Wi-Fi is enabled. Please make sure Wi-Fi connected to your phone is 2.4GHz (5GHz brand is not supported).
   • Make sure your smartphone is close to the device when connecting for the first time.
   • Check if you have entered the correct Wi-Fi password during Wi-Fi setup.
   • Make sure the distance between the bulb and router is less than 50ft.
   • Check whether the home network is stable by connecting bulb to another phone’s hotspot.

2. The bulb lost connection.

   • Check whether the device is powered on.
   • Check whether your home network is stable.
   • Check if there are too many devices connected to the router by connecting bulb to another phone’s hotspot.
   • Ensure the distance between the smartphone and the device does not exceed 50ft.
   • Delete bulbs connected in “My Devices” and reconnect the bulb to Wi-Fi following on-screen instructions.

3. How do I create a new scene on the Govee Home app?

   • Go to “My Devices” and select “Scene”.
   • Tap the “4” icon at the top right corner to create a new scene.
     Note: Select different classes based on your needs.

4. Can I use group control with voice assistance?

   • Please make sure your device is connected to Wi-Fi before using voice assistance.
   • Please set voice group control in Alexa/Google Assistant App.

5. What is the maximum number of devices I can connect via Bluetooth?

   • Typically, up to 6 devices can be connected devices may vary based on your smartphone brand.

6. How many bulbs can be connected to one phone?

   • Up to 50 bulbs can be connected to one phone if the network is normal.

THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS
Govee is a trademark Of Shenzhen Intellirocks Tech Co.,Ltd.
Copyright 02021 Shenzhen Intellirocks Tech CO.,Ltd. All Rights Reserved.

IC Statment

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.”

IC RF Statement

When using the product, maintain a distance of 20 cm from the body to ensure compliance with RF exposure accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Shenzhen Intellirocks Tech. Co., Ltd. is under license.

Customer Service

Warranty: 12-Month Limited Warranty
Support: Lifetime Technical Support
Email: support@govee.com
Official Website: www.govee.com
Youtube: @govee.official
Instagram: @Goveeofficial
Twitter: @Govee.smarthome

For FAQs and more information, please visit: www.govee.com

FCC Statement

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause harmtul interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>