HAGOR 1801 Info Tower Wall Installation Guide
- June 8, 2024
- HAGOR
Table of Contents
HAGOR 1801 Info Tower Wall Installation Guide
Art.-Nr.: 1801
Caution!
Technical devices are of considerable value. You should therefore handle the
components carefully during installation and protect them if necessary.
If necessary, the installation area should also be secured. Falling parts can cause injuries and material damage.
The materials included in the scope of delivery may not be suitable for the special conditions at the installation site. Please check this in advance and replace it with suitable materials if necessary.
If you are unsure about the installation of the product or have any questions, please contact us or other trained specialists.
Scope of delivery
Place the pedestal on a surface to avoid damage. screwing the base plate with the stand column, use the M8X40 countersunk screws for this.
Hang the wall mounting plates on the back of the column.
Position the column appropriately in front of the desired wall and mark the drill holes exactly on. Set the column aside and drill the required holes. please check Check the suitability of the wall in advance and select suitable mounting materials accordingly (These are not included). Now position and fix the pedestal.
Then lay all required cables inside the column and then slide carefully insert the front panel into the column from above. Avoid tilting the aperture to avoid damage.
Screw the VESA mount to the VESA mounting plate.
Hang the VESA mount at the desired height in the pillar’s locking steps.
Mount the VESA arms to the back of the screen. Please screw in the screws carefully and tighten to avoid damage. Use suitable screws from the supplied TV screw bag.
Now hang the screen with the VESA arms in the VESA mount and align Center the screen and fix it.
HAGOR Products GmbH | Oberbecksener Straße 97 | D-32547 Bad Oeynhausen | Telefon: +49(0)57 31-7 55 07-0 | Mail: [email protected]
Read More About This Manual & Download PDF: