ESi Controls 4 RF Pairing Receiver Instructions
- July 16, 2024
- ESi Controls
Table of Contents
ESi Controls 4 RF Pairing Receiver Instructions
If your RF receiver and room thermostat RF bond is lost, follow the instructions below.
- On your RF receiver, press & hold the M/A button until the MANUAL button flashes green. Release the button.
- On your thermostat, move the slider bar to the OFF position.
- Hold the A button, H button & + buttons until the green light on your RF receiver stops flashing.
- Move the slider bar to AUTO.
If both of the buttons on your RF receiver are flashing, isolate the power to your RF receiver for a full 10 minutes, then switch it back on and follow the steps above.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>