vodafone PlusBox 340 SipTrunk Router User Guide
- July 17, 2024
- Vodafone
Table of Contents
User Guide
PlusBox 340 SipTrunk Router
PlusBox 340 Quick Start Guide: ISDN Mode
Note:
Before you can use Anlagen-Anschluss Plus, you need to activate and to
configure PlusBox 340. Detailed instructions on how to achieve this are
available at www.vodafone.de/aaplus-support.
Connecting devices
Connect PlusBox 340 as follows with the telephone socket (TAE) and with your
ISDN PBX, for ISDN Voice
+ Data additionally with your network devices (further details see Chapter 2
of the user manual):
Setting up the configuration computer for DHCP
The computer you want to use to configure PlusBox 340 must obtain its IP
address dynamically via DHCP (Dynamic Host Configuration Protocol). This is
the default setting which is preassigned to most computers.
If this is not the case with your configuration computer, configure it using
the following TCP/IP properties (details see Section 5.1 of the user manual):
| Parameter | Selection |
|---|---|
| IPv4 address | Obtain an IP address automatically |
| DNS server address | Obtain DNS server address automatically |
Activating and setting up PlusBox 340
- Connect one of the ETH 0/0 to ETH 0/3 ports of PlusBox 340 via the yellow LAN cable with a LAN port of your configuration computer if you have not already done so.
- Open the Internet browser and enter http://192.168.2.1 or plus.box.
- Enter Username and Password (see PlusBox 340 underside), confirm with Log in:
- Follow the instructions of the activation wizard that opens, enter the 22-digit Modem Installation Code (MIC) from your welcome letter, click Continue and continue following the wizard‘s instructions.
- On the Setup page, Skip configuration storing option and continue following the wizard‘s instructions.
- Exclusively for ISDN Voice + Data: switch on (move slider to the right) and set up WiFi network:
- Exclusively for ISDN Voice + Data: enter WiFi Name, choose protection mode WPA2 PSK (recom- mended) and Band Selection, then change WiFi Password (in the window popping up).
- Continue following the wizard‘s instructions, then change password.
- Confirm message in the final page of the wizard with OK.
PlusBox 340 is now prepared for Voice service operation with Anlagen-Anschluss Plus as well as for Internet access (applies to ISDN Voice + Data exclusively). You can check the PlusBox 340 status on its Status page, see Section 6.5.1 of the user manual.
Note:
Before you can use Anlagen-Anschluss Plus, you need to activate and to
configure PlusBox 340. Detailed instructions on how to achieve this are
available at www.vodafone.de/aaplus-support.
Connecting devices
Connect PlusBox 340 as follows with the telephone socket (TAE) and with your
ISDN PBX, for ISDN Voice + Data additionally with your network devices
(further details see Chapter 2 of the user manual):
Setting up the configuration computer for DHCP
The computer you want to use to configure PlusBox 340 must obtain its IP
address dynamically via DHCP (Dynamic Host Configuration Protocol). This is
the default setting which is preassigned to most computers.
If this is not the case with your configuration computer, configure it using
the following TCP/IP properties(details see Section 5.1 of the user manual):
| Parameter | Auswahl |
|---|---|
| IPv4 address | Obtain an IP address automatically |
| DNS server adress | Obtain DNS server address automatically |
Activating and setting up PlusBox 340
- Connect one of the ETH 0/0 to ETH 0/3 ports of PlusBox 340 – exclusively Port ETH 0/3 for auto- matic IP Voice + Data conncection! – via the yellow LAN cable with a LAN port of your configuration computer if you have not already done so.
- Open the Internet browser and enter http://192.168.2.1 or plus.box.
- Enter Username and Password (see PlusBox 340 underside), confirm with Log in:
- Follow the instructions of the activation wizard that opens, enter the 22-digit Modem Installation Code (MIC) from your welcome letter, click Continue and continue following the wizard‘s instructions.
- On the Setup page, Skip configuration storing option and continue following the wizard‘s instructions.
- Exclusively for IP Voice + Data: switch on (move slider to the right) and set up WiFi network:
- Exclusively for IP Voice + Data: enter WiFi Name, choose protection mode WPA2 PSK (recommend-ed) and Band Selection, then change WiFi Password (in the window popping up).
- Continue following the wizard‘s instructions, then change password.
- Confirm message in the final page of the wizard with OK.
PlusBox 340 is now prepared for Voice service operation with Anlagen-Anschluss Plus as well as for Internet access (applies to IP Voice + Data exclusively). You can check the PlusBox 340 status on its Status page, see Section 6.5.1 of the user manual.
Vodafone GmbH, Ferdinand-Braun-Platz 1,
D-40549 Düsseldorf, Germany
Version 06/2024