Posey 8208L Alarm Locking Bracket Instruction Manual
- July 15, 2024
- Posey
Table of Contents
Posey 8208L Alarm Locking Bracket
Specifications
- Model: 8208L
- Mounting: Flat wall surface only
- Compatibility: Posey Alarm Locking Bracket REF 8208L
- Dimensions: Refer to Fig. 1, Fig. 2, Fig. 3, Fig. 4, Fig. 5 for installation details
FAQs
- Q: Can the 8208L be mounted on surfaces other than flat walls?
- A: No, the 8208L is specifically designed for mounting on flat wall surfaces only to ensure proper functionality.
- Q: What should I do if the alarm’s indicator lights are not visible to staff after installation?
- A: Ensure that the mounting location provides clear visibility of the indicator lights and consider relocating the device if necessary.
DESCRIPTION OF PRODUCT:
- The 8208L is designed to mount to a flat wall surface only.
Indications for Use
WARNING: Use of the 8208L may impede access to the on/off switch of the alarm.
OVERVIEW
Application Instructions
- Choose a wall location out of the patient’s reach, where the alarm’s indicator lights will be in clear view of staff.
- Screw attachment:
- Position wall bracket with the back (flat side) against a wall
- Using bracket as a template, mark spots to insert the screw anchors into the wall. (Fig. 1)
- WARNING: Make sure it is safe to drill and there are no pipes or electrical wires that could be damaged.
- WARNING: If using your mounting hardware, use a screw with a head diameter (or washer) large enough to secure the wall bracket/Narrow Vertical Slide to the wall.
- Drill holes were marked and install anchors.
- Place the Narrow Vertical Slide into the Wall Bracket so that the bottom of the Slide is flush against the bottom wall of the bracket. (Fig. 2a)
- Position Narrow Vertical Slide and Wall Bracket assembly over wall anchor holes; insert and tighten screws. (Fig. 2b)
- Slide the alarm onto the bracket from the top down until it is firmly in place. (Fig. 3a)
- Slide buckle lock on a Narrow Vertical Slide, to the top of the alarm. (Fig. 3b)
- Lock the buckle by pressing the buckle lock to engage the slot in the Narrow Vertical Slide. (Fig. 4)
- To remove the alarm, first unlock and remove the buckle lock. (Fig 5a-b) Then gently push the bracket release lever IN (Fig 5c) while sliding the alarm up and out. (Fig 5d)
- Replace buckle lock and lock onto Narrow Vertical Slide when not in use.
CONTACT
- TIDI Products, LLC
- 570 Enterprise Drive, Neenah, WI 54956 USA
- Phone: 1.800.521.1314
- International: +1.920.751.4036
- www.tidiproducts.com.
- © 2024 TIDI Products, LLC. All rights reserved. Posey is a registered trademark of TIDI Products, LLC. M6163
- REV C 03-20-2024
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>