Schreder FLEXIA FG Midi and Maxi Outdoor Straight Light Installation Guide
- July 15, 2024
- Schreder
Table of Contents
Schreder FLEXIA FG Midi and Maxi Outdoor Straight Light
Product Specifications
- Model: FLEXIA FG
- Voltage: 220-240V, 120-277V, 347V
- Power Consumption: 4 – 12 m
- Frequency: 50-60Hz
- IP IK Rating: 66 09
Product Usage Instructions
Installation:
Follow the respective installation instructions based on the language provided in the manual.
Assembly:
- Attach the knuckle joint angle (A) to the side-entry (B) using the specified screws with the correct torque.
- Connect the gas female side-entry (E) and gas male side-entry (F) as per the manual.
Maintenance:
Do not touch the CR-KIT until it has cooled down. Follow the maintenance instructions provided for CR-KIT EU and CR-KIT CSA/UL.
Frequently Asked Questions
Q: Can the product be used with a different voltage than specified?
A: No, it is recommended to use the product within the specified voltage range for optimal performance and safety.
Q: How often should maintenance be performed on the product?
A: Regular maintenance is recommended as per the guidelines provided in the manual to ensure proper functioning of the product.
TOOLS
INSTALLATION INSTRUCTIONS
- A. Knuckle joint angle
- B. Knuckle joint Side-Entry 60×50 square
- C. Knuckle joint Side-Entry penetrating Ø48mm
- D. Knuckle joint Side-Entry enclosing Ø60mm (only for Midi)
- E. Knuckle joint 1” gas female side-entry
- F. Knuckle joint 1” gas male side-entry
- G. Knuckle joint Surface
- H. Knuckle joint Rear bracket
- I. Maintenance CR-KIT EU
- J. Reassembling
- K. Maintenance CR-KIT CSA/UL
- L. Reassembling
SAFETY INSTRUCTIONS
The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. Always switch off the power prior to installation, maintenance or repair activities.
RISK GROUP 2
Hazardous optical radiation may be emitted from this product. Do not stare at the luminaire when operating as it may be harmful to the eyes. The luminaire should be positioned so that prolonged staring at the luminaire at a distance of less than 0.94m is not expected.
ENERGY EFFICIENCY
This product contains a light source of an energy efficiency class G or higher or see table on first page.
PVC INSULATION AND Y CONNECTION
in case of PVC insulated mains cable, the installer MUST ensure that the WHOLE cable is protected against climatic conditions, especially UV rays and rain, by making sure that the cable is contained inside the luminaire and pole. Y-connection: In case of damage to the wire. it has to be replaced onlv bv the manufacturer. distributor or bv an expert. to avoid risks.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>