JL AUDIO 94722 Toyota Tacoma Double Cab Vehicles Installation Guide
- July 9, 2024
- JL AUDIO
Table of Contents
INSTALLATION GUIDE
for the
SBX-T-TACDCG3/10TW1
SKU# 94722
2016-Up Toyota Tacoma Double Cab
Enclosure Type: Sealed
Driver Type: 10TW3-D4
Nominal Impedance: 2 ohms
Continuous Power Handling: 400 watts (RMS method)
94722 Toyota Tacoma Double Cab Vehicles
Important
- Installation requires appropriate tools and safety equipment. Professional installation is recommended.
- If you prefer to perform your own installation, please read this installation guide completely before beginning.
- Before cutting or drilling, check for potential obstacles behind mounting surfaces.
- Mount this product securely to prevent damage or injury in severe conditions.
INCLUDED HARDWARE
| BOM ID | Qty | SKU | Description |
|---|---|---|---|
| 1 | 2 | 151329 | 3/8” ID, 3/4” OD x 3/8” Long Aluminum Spacer |
| 2 | 2 | 155079 | L-Bracket |
| 3 | 2 | 155078 | M6 x 14mm Flanged Hex Head Screw |
| 4 | 2 | 155077 | M6 x 20mm Flanged Hex Head Screw |
| – | 1 | 194157 | Vibra-Tite 132 (not shown) |
| – | 2 | 150249 | Foam Tape (not shown) |
STEP 1
Empty the rear seat area. STEP 2
Fold the passenger side seat bottom forward.
STEP 3
Remove the two headrests on the passenger side seat back.
STEP 4
Fold the passenger side seat back down to access the rear storage pocket,
and empty the pocket. STEP 5
Locate the small, plastic tab in the center of the storage pocket floor. Using
a razor knife, carefully remove the tab. STEP 6
Peel the adhesive backing and place Foam Tape strips into the storage pocket,
as needed. Route speaker cable to the inner side of the storage pocket. STEP
7
Connect the speaker cable and place the nclosure into position, as shown.
Remove the factory bolt from the back of the torage pocket on each side of the
enclosure. These will not be reinstalled. STEP 8
Apply Vibra-Tite 132 to an M6 x 30mm Flanged Hex Head Screw, pass it through
the slot in the L-Bracket, through a 3/8” Long Aluminum Spacer, into the
factory location, and hand tighten. Apply Vibra-Tite 132 to an M6 x 14mm
Flanged Hex Head Screw, pass it through the slot in the 3/8” Long Aluminum
Spacer, into the insert in the enclosure, and hand tighten.
Repeat the process for the opposite side. STEP 9
Fully tighten all four fasteners. STEP 10
Fold the seat back into place and reinstall the headrests.
CONGRATULATI ONS!
You have completed the installation for this model! Enjoy your new
Stealthbox®!
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of your vehicle.
| Location / OEM Speaker Size | Suggested JL Audio Speaker Models |
|---|---|
| Coaxial Models | Component Models |
| Front | Dash / 2.75-inch |
| Door / 6×9-inch | C1-690x (1) , C1-690tx (1) , C2-690tx (1) |
| C2-650x (1) , C5-650x (1) | C1-650, C2-650, C3-650, C6-650cw (2) , |
C7-650cw
(2)
Rear| Door / 6.5-inch| C1-690x (1) , C1-690tx (1) , C2-690tx (1) C2-650x (1)
, C5-650x (1)| C1-650, C2-650, C3-650, C6-650cw (2), C7-650cw (2
1 – Installation may require adaptor
2 – Component woofer only Please review the warranty information included with
each product for details. Warranty is valid only if the product was purchased
from an Authorized JL Audio Dealer. Authorized dealer status can be verified
with the Dealer Locator on www.jlaudo.com. International Warranty: Please
contact your country’s JL Audio distributor for specific warranty details.
© Garmin Ltd. or its subsidiaries. All rights reserved. • Garmin, JL Audio,
Stealthbox, and How we play. are trademarks of Garmin Ltd. or its subsidiaries
and are regstered in one or more countries, including the U.S. The JL Audio
logo, the How we pay logo, the Stealthbox logo, and the SBX logo are
trademarks of Garmn Ltd. or its subsidiaries. Product images shown are for
illustrative purposes only and may differ from the actual product. Due to
continuous product development, all specifications are subject to change
without notice.
JLA-SKU# 011600 • ver. 04.18.2024
• 10369 NORTH COMMERCE PARKWAY
• MIRAMAR, FLORIDA • 33025 • USA
954-443-1100
www.jlaudio.com