naeo Ultrasonic Aroma Diffuser Installation Guide
- July 9, 2024
- naeo
Table of Contents
naeo Ultrasonic Aroma Diffuser Installation Guide
WARNING
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children should not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision. Only to be used
for ambience diffusion purposes, do not inhale.
Use in an environment between 10°C and 30°C.
This appliance is only to be used with the supplied power adaptor.
For optimal maintenance, use mineral water (bottled or tap water).
Do not exceed the maximum water level (100 ml).
Always add water to the tank before adding essential oils.
Do not use pure essential oils without water.
The appliance is only to be used with the recommended vaporizing medium. The
use of other substances may give rise to a toxic or fire risk.
Continuous use of the diffuser may, in the long term, wear out the product and
shorten its lifespan.
Unplug the appliance before any maintenance such as cleaning or filling.
Do not remove the lid or cover the diffuser when the appliance is in use.
Frequently change the water in the tank to avoid any dirt build up that may
damage the appliance.
Clean the water tank every 3 days. Do not use chemical products (such as
acids, alkaline, etc.) or any corrosive detergents to clean the appliance.
To Descale: Fill with equal parts white vinegar and water, operate the
appliance for an hour, then turn off and let it sit for an hour.
Be aware that high humidity levels may encourage the growth of biological
organisms in the environment.
WARNING
Do not permit the area around the diffuser to become damp or wet. If
dampness occurs, turn off the diffuser. Never leave water in the tank when the
appliance is not in use.
Empty and clean the diffuser before storage. Clean the diffuser before next
use.
Warning: Micro-organisms that may be present in the water or in the
environment where the appliance is used or stored, can grow in the water tank
and be blown in the air [causing very serious health risks when the water is
not renewed and the tank is not cleaned properly every 3 days.
Empty the tank and refill every third day. Before refilling, clean it with
fresh tap water or cleaning agents if required by the manufacturer.
Remove any scale, deposits, or film that has formed on the sides of the tank
or on interior surfaces, and wipe all surfaces dry.
Do not immerse.
In case of water infiltrations into the appliance, unplug the diffuser
immediately and leave it to dry for at least 3 days before reusing it.
Do not operate outdoors. This appliance is intended for indoor use only.
NOTE: People suffering from perfume sensitivity should be cautious when
using this product with any fragranced oils. When storing the appliance, let
all parts dry completely before storing away in a cool, dry place until the
next use.
IMPORTANT: We recommend you clean your aroma diffuser every time you
change oils as essential oils can build up over time.
DETAILED DIAGRAM OF THE COMPONENTS
PREPARATION OF THE DIFFUSER
-
Insert the cable’s connector into the DC jack input at the back of the base of the diffuser.
-
Place the diffuser on a flat and stable surface and away from the edge.
-
Remove the diffuser’s outer and inner cover.
-
Pour mineral water (bottled or tap water) into the water tank up to the maximum level indicated (100 ml).
-
Add a few drops of essential oils (3-4 drops) to the water tank.
CAUTION: adding too much essential oil can cause damage to the ultrasonic plate. -
Replace the inner cover and the outer cover on the diffuser.
-
Plug the USB connector into a 5V/1A power source, such as a USB wall adapter (not included) and plug into an electrical outlet.
OPERATION
This diffuser has 1 func�on bu�on on the front side:
ON/ OFF :
- 1″ press: turn on the diffuser, continuous mist and color changing light.
- 2nd press: change to continuous mist and fixed light.
- 3rd press: change to continuous mist with light off.
- 4th press: diffuser turn off
Remark: The diffuser will stop misting when the water level becomes too low. To use the diffuser again, pour water into the water tank by following the “Preparation of the diffuser” steps.
CARE AND MAINTENANCE
You are advised to change the water frequently in the tank and clean the diffuser every 3 days, particularly if you want to change the fragrance to be diffused.
Air Outlet:
Empty the water in the opposite way to the air outlet. Do not empty the water
in the air outlet, this would damage the diffuser.
- Turn the appliance off and unplug it.
- Remove the covers and empty the water on the opposite side of the air outlet. Do not empty the water in the air outlet, this would damage the diffuser.
- Clean the diffuser water tank using a soft damp cloth. If needed, use a little white vinegar strongly diluted. Do not use corrosive detergents. Carefully rub the ceramic disc with a cotton bud being careful not to scratch it.
TECHNICAL SPECIFICATIONS
- Model: GD-D11
- Item number: 5704901
- Input power: DC5V = 1A (no adaptor provided)
- Tank capacity: 100ml
- Dimensions (approx): 105*100mm
- Ceramic disc lifespan: +/- 3000 hours
Correct Disposal of this product. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling. Button cells, like any cell or battery, must be collected at collection points, in order to be valued.
Manufactured by: Everview Trading Ltd, 5 West Victoria Dock Road, DUNDEE, DO1 3IT UK Green Delta Ltd c/o SEDIS Logistics, 7 Rue des Sablières, 7522 Blandain, Belgium Made in China
complies
Electrical equipment (Safety) Regulations 2016 The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012
This complete declaration of conformity is available upon request for relevant enquiries.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>