Qingdao P0203288A eBike LED Display DY12 User Manual

July 8, 2024
QINGDAO

Qingdao P0203288A eBike LED Display DY12

Product Usage Instructions

Installation

To install the eBike LED Display DY12 ModelP0203288A, follow these steps:

  1. Ensure the handlebar diameter is 22.2mm to fit the display.
  2. Connect the pins as per the Pin Connection Definition provided in the manual.

Operation

To operate the eBike LED Display DY12 ModelP0203288A:

  • Use the buttons on the display to navigate through different assist levels and functions.
  • The light sensor automatically adjusts display brightness based on ambient light conditions.
  • The walk assistance feature helps when pushing the bike manually.

Maintenance

To ensure optimal performance, keep the display clean and dry. Avoid exposing it to extreme temperatures or water damage.

Frequently Asked Questions

Q: Can I upgrade the display using the CAN BLE OTA Upgrading feature?

A: Yes, you can upgrade the display using the CAN BLE OTA Upgrading feature as mentioned in the specifications.

Q: What is the waterproof level of the eBike LED Display DY12 ModelP0203288A?

A: The waterproof level of the display is IPX6, meaning it is protected against heavy rain and splashing.

Q: How do I adjust the assist level on the display?

A: You can adjust the assist level using the buttons on the display to switch between different levels, including an AUTO mode.

eBike LED Display DY12
Model:P0203288A

Product Introduction

  • Category:eBike LED Display
  • Model:P0203288A
  • Appearance:

Specification

Rated Voltage(DCV) 36V/48V
Working Temp(℃) -20~50
Storage Temp(℃) -25~55
Waterproof Level IPX6
Display Type LED
Assist Level 4 Level(Including AUTO)
Light Sensor Available
Walk Assistance Available
Light on/off Available
Data Display Assist Level,Battery Capacity,Error Code etc.
APP Available
Communication CAN BLE
Upgrading OTA Upgrading

Dimension

Display size: 82.0354.4642.75mm,adapted handlebar diameter:22.2mm

Pin Connection Definition

FCC Statements

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

RF Warning:
The device has been evaluated to meet general RF exposure requirement, The device can be used in portable exposure condition without restriction. Federal Communication Commission (FCC) Radiation Exposure Statement Power is so low that no RF exposure calculation is needed.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

QINGDAO User Manuals

Related Manuals