TELOX TE620G POC Network Radio User Guide
- June 13, 2024
- TELOX
Table of Contents
TELOX TE620G POC Network Radio User Guide
Thanks for choosing our product!
This Quick Start Guide only applicable to: TE620G.
Before using the product, please read the Quick Start Guide to fully benefit
from it.
Note
- Warranty period is 1 year from date of purchase.
- This product involves constant upgrading and/or improvement, our company reserves the right to change the specifications of software and/or hardware mentioned in this operating guide without any prior notice. The product specifications and information mentioned in the operating guide are for reference only.
Check List
Notice:
Please check the above accessories before you discard the packing material. Please contact your local dealer immediately if there is any missing or damage parts.
Before Use
Charging
Connect the LTE handheld and power adapter using the USS Data Cable.
Red light on the LTE handheld indicates battery charging in progress.
Green lights on indicates fully charged.
Notice:
Always use Telox Original batteries and chargers. The warranty does not cover damage caused by non-Telox batteries and/or chargers.
Caution
- Although your device is quite sturdy, it is a complex piece of equipment and can be broken. Avoid dropping, hitting or bending, or sitting on it.
- Make sure the charger/USS port, microSD card/SIM card slot covers are properly seated, with no foreign objects obstructing the seals.
- Do not use the charger/USS port for charging, data transmission, etc. until the phone is completely dry.
- Do not store the device under any circumstance containing electronic erosive material.
- Avoid to pull the device up by holding the antenna or accessories.
- Please power off and unload the battery before cleaning the device.
- Using dry and clean lint-free cloth or hairbrush to keep the device and charger docking port clean.
- Avoid to use any chemical agent including detergent, alcohol, aerosol spray or oil preparations as cleaning solution.
- Dry your device completely after cleaning and before using it again.
FCC Statement
15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
15.105 lnfonnation to user.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) Information:
This product meets the government’s requirements for exposure to radio waves.
The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety margin designed
to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6
W/kg averaged over one gram of tissue. This device was tested for typical
body-worn operations when the device used at 25mm from front face and 10mm
from the product, 0mm from the belt, for maintain compliance with FCC RF
exposure requirements. The use of belt clips, holsters and similar accessories
should not contain metallic components in its assembly. The use of accessories
that do not satisfy these requirements may not comply with FCC RF exposure
requirements, and should be avoided.
CE Warning
-
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions. -
The product shall only be connected to a USS interface of version USS2.0 or higher.
-
Adapter shall be installed near the equipment and shall be easily accessible.
-
The operating temperature of the device can’t exceed 40 t and shouldn’t be lower than -20t.
-
The plug considered as disconnect device of adapter.
-
The device complies with RF specifications when the device used at 5mm from the body without belt-clips, 0mm from the body with the belt-clips, 25mm from the face.
-
The band 5150-5350MHz indoor use only.
Hereby, Telo Communication (Shenzhen) Co., Ltd declares that this Mobile phone product is in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU. This product is allowed to be used in all EU member states.
Telo Communication (Shenzhen) Co., Ltd
Tel:+86-755-86950766
E-mail:sales@telox.com
Add:6/F, No.42 Liuxian 1st Road, Bao’an District, Shenzhen, China
www.telox.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>