Robox Design WC2H 9JQ Insulated Tap Enclosure Instruction Manual
- July 8, 2024
- Robox Design
Table of Contents
Robox Design WC2H 9JQ Insulated Tap Enclosure
INSTRUCTION FOR USE
INSTALLATION
-
STEP.1
Place the tap box enclosure over the tap to be protected.
-
Step 2:
Ensure the box is level. Mark holes in top keyhole slots. Remove box use a 6mm drill and add plugs.
-
Step 3:
Add top two screws. Leave proud by 2 to 3mm.
-
Step 4:
Replace box on to keyhole slots. Pull down to lock box into required position.
-
Step 5:
Check level. Mark bottom screw positions. Remove box drill holes and add plugs.
-
Step 6:
Replace box onto top screws. Pull down into position. Check alignment. Add bottom screws. Fully tighten all screws. Ensure box is firmly attached to the wall.
CUSTOMER SUPPORT
71-75 SHELTON STREET
COVENT GARDEN | LONDON | WC2H 9JQ
TEL: 0330 133 8910
hello@roboxdesign.co.uk |
www.roboxdesign.co.uk
