Direct Colors DC-WAX-HGL-1GAL ProWax Polish Concrete Floor Wax Clear Gloss User Guide
- June 13, 2024
- Direct Colors
Table of Contents
Direct Colors DC-WAX-HGL-1GAL ProWax Polish Concrete Floor Wax Clear Gloss
STEP 1: PREPARE SURFACE
- Sweep away loose dirt and debris.
- If reapplying wax on previously waxed floors:
- Strip the floor when wax appears cloudy or hazy
- Use floor stripper to remove old wax and finish (refer to Floor Wax Remover guide).
TOOLS FOR THE JOB
- **SURFACE PROTECTION
**
- **PERSONAL PROTECTION
**
- **APPLICATION TOOLS
**
- CLEAN-UP
MAINTENANCE
- Sweep daily using dust mop or cloth.
- Clean with a neutral pH cleaner such as ProClean Degreaser™ and mop bucket or automatic scrubber.
- Perform light cleaning to remove surface soils, stains, and maintain gloss and color.
- Spot treat high-traffic areas as needed.
CAUTION: May be harmful if swallowed or ingested. Contact with skin can cause mild irritation. Avoid contact with eyes.
Coverage per Gallon:
Approximately 500 Sq. Ft 2 Thin Coats Recommended
Approx. Dry Time:
6 Hr. Recoat 24 Hr. Foot Traffic
Temperature Range:
Apply Between 60°F(16°C) and 95°F (35°C)
Tools Clean-Up:
ProClean Degreaser™ and Warm Water
STEP 2: PROWAX POLISH™ APPLICATION
GENERAL APPLICATION:
- Use a sponge mop, microfiber push mop, or floor coater.
- Dampen applicator in warm water and wring out excess moisture.
- Start at a far corner to maintain a clear exit path.
- Wet applicator in Pro Wax Polish™ and apply first coat in one direction only.
- Angle applicator toward inside edge for excess wax runoff.
- Ensure thin and even application, re-dip in ProWax Polish™ as needed. Overlap each pass slightly until the floor is coated.
- Allow 6 hours between coats (two thin coats recommended).
- Test coat hardness with thumbnail; if dents or scratches, allow more curing time.
- Apply second coat in the opposite direction, following the same method.
PROFESSIONAL APPLICATION:
- Apply a minimum of 4-5 coats before burnishing to enhance shine and durability.
- Pad recommendations for burnishing with a floor machine:
- Preferred: Natural fiber pads.
- Alternatives: Tan, beige, or light blue synthetic pads
- Follow manufacturer’s guidelines for machine operation and safety precautions.
Disclaimer: Direct Colors does not warranty or guarantee results (outcomes). Concrete variations or improper application may cause unintended results. Test product on an inconspicuous or small area and allow to fully cure to ensure compatibility and desired result.
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>