Torin ATZ Series Heavy Duty Jack Stands Owner’s Manual
- July 2, 2024
- Torin
Table of Contents
HEAVY DUTY
JACK STANDS
OWNER’S MANUAL
INSTRUCTIONS FOR USE
SPECIFICATIONS
| Capacity | Lifting Range |
|---|---|
| 7Ton | 115/8~ 159/16 inches |
| 12Ton | 12:5/8 ~ 18-1/2 inches. |
| 22Ton | 13-3/4 ~ 191116 inches |
PLEASE READ THIS MANUAL CAREFULLY BEFORE USE
IMPORTANT:
Study, Understand and follow all instructions failure to heed this warning may
result in personal injury and/or property damage.
WARNING:
Read-Study and understand all warning and operating instructions prior to use.
DO NOT OVERLOAD these jack stands beyond their rated capacity. These jack
stands are designed for use on hard level surfaces only. Center Ioad on saddle
prior to lfting. Use as a matched pair to support one end of a vehicle only.
Stands are not to be used to simultaneously support both ends or one side of a
vehicle. No alterations shall be made to this product. Failure to heed these
warnings may result in damage to jack stands and/or failure resulting in
personal injury or property damage. Inspect before each use. Only attachments
and / or adapters supplied by the manufacturer shall be used.
OPERATING INSTRUCTION:
- Be sure to bend the bar after inserting ratchet into frame to prevent ratchet from detaching out of the frame.
- Put the jack stands on hard level ground
- Adjust height by pulling up on ratchet
- Place load on the center of saddle for safety it is strongly recommended that lifting means not be removed while jack stands are supporting the vehicle.
- Secure ratchet by turing stopper to hold load. Make sure stopper has been securely inserted.
- Release stopper and let ratchet glide down to the lowest position when storing the jack stand.
- Inspect before each use DO NOT USE IF BENT BROKEN OR CRACKED COMPONENT ARE NOTED. Prevent corrosion. Clean as needed and wipe with an oily cloth and keep in dry area when not in use.
Visual inspection shall be performed before each use of the stand by checking abnormal condition, such as cracked welds, leaks and damaged, loose, or missing parts if stand is believed to have been subjected to abnormal load or shock inspection shall be made by authorized repair facillty. Equipment that appears damage or worn or operates abnormally shall be removed from service until repair. Repair should be made by authorized repair facilty. Annual inspection of the stand is recommended and should be made by the manufacturer’s or supplier’s authorized repair facillty to ensure that you stand is optimum conditions and that the stand has correct decals and safety labels specified by the manufacturer.
Distributed by / Distribuido por:
TORIN INC.
Ontario, CA 91761
FOR CUSTOMER SERVICE
PARA EL SERVICIO PARA EL
www.torin-usa.com/support
Made in China / Hecho en China
www.torin-usa.com